more maintenance on the gsx1400 with throttle bodies "how to" sync using the carb tune pro !!!
Пікірлер: 23
@Jamboliner3 жыл бұрын
Thanks for sharing.
@stephenanderson34402 жыл бұрын
Got the throttle bodies set on my gsx1400 transferred the bike completely mines was running really lumpy round town.
@KeepItWheel2 жыл бұрын
Thats great buddy hoped the video helped you out 👍🏻
@stuartmiller96483 жыл бұрын
What would the symptoms be of needing the throttle bodies synced..? Great video by the way.
@KeepItWheel3 жыл бұрын
Could be a slight delay when opening the throttle almost like a stutter ! Also revs on tick over may fluctuate! Poor fuel economy hope this helps 👍
@mike309saa4 жыл бұрын
Great vid. How often should this be done mile wise? I bought my K5 GSX14 3 years ago had 7k on the clock hardly used and it's now done over 43k. Do you reckon it's likely to be out? Also I'm yet to check your other vids but have you done one on adjusting the throttle position sensor?
@KeepItWheel4 жыл бұрын
Think its every 6k to 7k miles or yearly is recommended no no vid on the tps but its the same on most early suzukis eg tls tlr and gsxr etc hope this helps 👍🏻
@kevinhancock40643 ай бұрын
@KeepItWheel they over complicate it in manual.but not so bad I'm.checking.mine again tomorrow hopong to get this tool.over next few weeks also can't wait .....rebuilt above crank last year new base gasket hg bolts the lot
@IMAM201212 жыл бұрын
Hi great video! Just wondering do you need to unplug both map sensors? The one under the tank and the one on the airbox?
@KeepItWheel2 жыл бұрын
No buddy leave them both plugged in 👍🏻
@flibbertigibbet6200 Жыл бұрын
QQ is there a screw adjustment for each throttle body as to me it sounded like you said there was only one for cylinder 1 and 2 and 1 for cylinder 3 and 4 and one in the middle for both sides. If that is the case how can you level out 1 and 2 etc? Thanks
@kevinhancock40643 ай бұрын
There's 1 for 1&2 then another for 3&4 (both underside ) then top screw to get 2+2equal . Hope thus makes sense
@alexboyde81293 жыл бұрын
Embarassing to admit to but I did not realise fuel injected bikes need this doing I thought it was just carbed bikes. Yes runs so much smoother can hear it straight away!
@KeepItWheel3 жыл бұрын
Cheers buddy thanks for you comment 👍🏻
@scottashcroft65143 жыл бұрын
Good video, how much do you charge for this? Or know anywhere I can get mine done? I'm in Yorkshire. Cheers
@KeepItWheel3 жыл бұрын
We don't offer this as a service sorry😐 Its just to show that people can do it their selfs. Buy the tool and a Haynes manual and you will be surprised how easy it is! Failing that I recommend searching for a decent local motorcycle mechanic (Research & Check Reviews Obviously) rather than main dealers that just wanna pull ya pants down👍
@stevedunn55463 жыл бұрын
Hi great vid. I have a 2007 GSX1400. Had it 12 years it has now decided not to rev past 5 grand when im riding. Up until then it sounds great. Is this a sensor problem do you think?
@KeepItWheel3 жыл бұрын
Hi, its really hard to diagnose on-line... there are many things to check to be able to give you a decent answer(s) could be a fuelling issue, filters, valves etc do you have any fault codes? Would be a good place to start sorry can't be of more help😔
@stevedunn55463 жыл бұрын
Will check the fault codes cheers. Air filter is K+N all clean no problem. Might be fuel.
@KeepItWheel3 жыл бұрын
yeah have a check on the codes....defo wouldn't be air filter more fuel filter like you said.....good luck and let us know how ya get on👍
@paulsteele32912 жыл бұрын
If bike has been remapped for aftermarket end cans would this need to be taken into count or doesn't it make any difference to throttle body balance
@KeepItWheel2 жыл бұрын
Hi bud ! Balancing the the throttle bodies would not effect the mapping on the bike as the power commander works off the TPS(throttle position sensor) sensor!