Correct repair procedure in case of broken front axle of truck due to overload which not every mechanic can do #repair #correct #broken #front #axle #truck #overload #mechanic
Пікірлер: 22
@dadbehrouhbakhsh62620 күн бұрын
The axle broke due to a combination of overloading and bad roads..I'm not sure how long this new welded axle will hold to the same treatments..
@zecasiqueira926214 күн бұрын
Esse rapaz de óculos e bom de torno e proficional
@chickenlife631725 күн бұрын
RIP truck driver.
@mutterschied20 күн бұрын
Why? The welded surfaces 'r' stronger than when processed, you engineer...
@user-dj5gf9jp8g25 күн бұрын
Cool work thanks 👍
@j.conxcara3814 күн бұрын
ya que han hecho una reparación tan chapucera, podrían haberlo compensado poniéndole un refuerzo.
@holycrapski9 күн бұрын
A little knowledge is a dangerous thing (For others in this Case).
@PeterChapman-rg6gr24 күн бұрын
Some poor truck driver is going to regret that this bodge was ever fitted to his lorry.
@thomasbor23 күн бұрын
say good bye to castor and camber angles....
@TheUltimate6525 күн бұрын
Did the have Full controll over the camber angle then...🤔
@user-si5qz7rp7b25 күн бұрын
СТО раздолбай моторс придумало новую технологию восстановления передней балки всем перекупам нужно срочно брать с них пример.
@Bosjak6321 күн бұрын
Посмотрел твои видео Раздолбай моторс как раз у тебя, у них хотя бы в цеху чисто Да и технология реставрации балки несмотря на кажущуюся примитивность вполне рабочая, это видно по тому как они её исполнили. Сразу заметно что не в первый раз !
@user-si5qz7rp7b20 күн бұрын
@@Bosjak63 у меня хоть верстак и тиски есть.
@user-si5qz7rp7b19 күн бұрын
@@Bosjak63 чтобы кого ни будь критиковать за бардак и грязь в цеху нужно иметь хотя бы гараж а не арендованное парковочное место.
@Bosjak6319 күн бұрын
@@user-si5qz7rp7b Тут проблем нет.. Был гараж - был порядок Сейчас арендованое парковочное место, ничего не изменилось - так же в чистоте и порядке!
@freshhealthy811825 күн бұрын
❤❤❤❤
@mrphotomanseattle25 күн бұрын
Please explain why they drilled and drove in the pin. Is it for stress relief?
@bills609325 күн бұрын
The pin makes the joint stronger since they were only able to weld around the outside. So the pieces are both pinned and welded together. Probably should have used a shorter pin that set below the surface a bit, and then welded the pin in place at both ends. Such a repair in the West would get you arrested, though.