Spektrum NX Series Tutorials - Dual Rate & Expo

[@TheRCAirMarshall]

Thanks for watching! Check the description for links on where to buy your own Spektrum NX Series Transmitter! Please like, share, subscribe, and turn on your notifications!

[@ajslug]

Thank you! I figured out the DR/expo for each stick, but didn't even realize they can share a stick. I was looking for a combo stick to program. ( Old DX7 way)

[@0134harley]

Hi , i am a beginner RC pilot, I didn’t know what is Dual Rates and Expo , but after watching your tutorial , now i am able to fine tune my TX , thanks for the video , one of the best 😍

[@ducktoo]

Dave, your videos are very helpful and very thorough and clear. Thanks so much.There is something probably very simple that I just don't understand on dual rates. I have a Spectrum DX8, I typically use switch C for rates, which has three positions. On a fresh new model assigning switch C for rates, usually everything works as it should, meaning when the switch position is at the top it displays the curve for position zero, I move the switch to position one and it shows curve one, I move the switch to position two and it displays the curve for position two. Everything as it should be. But after I monkey with things a bit, sometimes, somehow it all gets scrambled. I don't seem to be able to unscramble it. Now, when I physically set the switch to position zero, for example, it displays curve 1 instead of curve 0. Said another way, the physical switch positions do not correlate correctly to curve zero, curve one, and curve two. Dave if you understand what I'm trying to say can you please help me understand this problem it's happened on several models. However, many other models I've set up with no problem. Thanks again, your work is much appreciated.

[@mikessi]

Thanks Dave. I have learned some of this by trial and error, but now I will know for sure what all the settings can do. Keep 'em coming.

[@mikebird8290]

Thanks DAVE FOR A VERY WELL EXPLAINED LESION ON HOW TO USE ARE SPECTRUM TRANSMITER PROPERLY. VERY HELPFUL THANKYOU SIR.

[@jcb6713]

I've heard of programming control surfaces on different switches, but now I understand what they were doing...tnx

[@ctfirepitpistolandcigar512]

Great vid, I was confused with the curves but you explained it do well/ thank you!

[@irwinwka]

In the old day the throttle trim was mechanical and you could just go to full up trim to the bottom. Do you know of a way to make the electronic throttle trim move more quickly. Someone said you could make the trim essentially a three position switch. Do you know how or where to look? Thanks

[@polyscient]

Hi guys, if you're having trouble with the rates and expo values being only dashes, make sure you have each position of the switch, 0, 1, and 2, mapped to 0, 1 , and 2 at the bottom. To do this, put the switch in each position and highlight the corresponding number at the bottom, and not either of the other numbers, for each position.

[@StanMills]

At 11:35 you show a Rudder setup. But all the numbers are different and you didn’t say anything about what they meant. What is going on with the Rudder settings?

[@stevestonrcguy5393]

Great explanation 👍

[@davennysouthern8717]

thanks mate

[@boss2234]

👍🏼👍🏼👍🏼🇺🇸🇺🇸