Steering box overhaul

[@RGMeyer]

Thank you for making this video. I found it very helpful on my rebuild.

[@67Stang]

I know this is a very old video but it is still helpful. Considering rebuilding my steering box. This helps show that it is not hard just takes time and patience.

[@ericschulte1853]

Thanks so much, an excellent tutorial reference. I am rebuilding my box right now!

[@MrJcardimen]

Excellent tutorial. Very helpful.

[@28500jojo]

Merci, tres bien expliqué, il y a combien de billes dans le ball nut a recirculation d'huile ? , moi j'en ai compté 62 billes mais j'ai l'impression qu'on peut en mettre plus

[@jannoort7651]

Merci beaucoup!

[@senorluisescalante]

Awesome! Torque Spec's? 18~42 in lbs or Foot pounds for the ball gate clamp? Foot pounds seems like a lot????How long are the race bearing parts left in the freezer? Pre load only to 4 to 5 in lbs or foot pounds for worm shaft adjuster? Or complete torque is 4 to 5 inch or foot pounds?

[@caseyl2971]

Where did you get the rebuild kit?? I have a 1966 Ford Falcon Van that needs the steering box rebuilt

[@Thunderdeome]

I bought the kit from a mustang part seller like mustang unlimited or cj pony part

[@robertnot6022]

What grease or oil did you use in the manual box, and how much is needed?

[@Thunderdeome]

I use lithium grease, and fill in completely the steering box

[@cyrilleferme8321]

I would like to rebuild a mustang 68 steering box manual steeting , can you give me the part list( bearings ,seal ,Gasket)

[@starbattles1]

I just did one. I reused everything. As long as water never got in it all the parts inside should be ok. It never see's high loads, or high stress, or friction.