Conversational Programming in Tormach's PathPilot

PathPilot is more than just control software, it's a powerful tool that can help make your metalworking easier. Daniel Rogge walks through the conversational interface of Tormach's PathPilot software and how you can use it best.
Be sure to subscribe for updates on everything Tormach: goo.gl/sWeCs7
If you want technical support, please follow these instructions to open a Support Ticket: tormach.com/how-to-submit-a-s...
Join the Tormach Community Forums here: forums.tormach.com/?...
There are several ways to contact Tormach Technical Support.
Tormach Technical Support Page: tormach.com/support?...
Tormach Technical Support Contact: tormach.atlassian.net/service...
About Us: At Tormach, we're dedicated to providing exceptionally engineered products, technical support, and customer service at the lowest possible cost. Our focus is to help you realize your CNC goals through tools and resources that transform your concepts into real products. Connect with us:
Visit our website: tormach.com/?...

[@basuramanya]

Looking Good Rogge. Some one I know mentioned getting a Tormach and I looked up the channel and bam..there you are.

[@BlueSwallowAircraft]

Thanks for the video. Its very helpful as I am just starting to try and use the Conversational on my 1100.

[@cogentdynamics]

I love my new Tormach 440 mill. Your videos are very helpful, thank you. I have a question: using the conversational profile tab, how would I radius the corners on just one side of a part? I guess the same question might apply if we were doing a pocket but wanted larger corner radius on two corners but not 4? Is this possible? I appreciate your time and work!

[@billgreathouse1913]

Probably a bit late to the party but I have a request for development. How about adding tabs for point to point milling? Similar to how the prototrak control has. It is often that I wish that I could mill an irregular profile without the need to modle something. Have a toggle in the upper right, like with drill vs tap, for profile vs pocket. Each segment or radius would have a end or continue prompt. This would link each move. Until end was selected. Then move to retract position.

[@beatboxx713]

I agree 100%, sometimes I just want to clean up a basic profile... It would be nice to have a point to point tab where maybe even u could fill inn a table with x and y positions...

[@mickeymouse-lu2yk]

Hoping a refresh will be made that talks to the material selection for feeds and speeds recommendation capability, this is a totally awesome capability if i can get it to work - should be super easy - unfortunately for me i can’t change the material - filed is not letting me.

[@toddsutton5672]

So your limited to sqaure or round on profiles?

[@kyleflynn4384]

can u thread mill a Taperd pipe thread in conversational in path pilot?

[@tormachinc]

Yes, you can do a tapered thread operation in conversational. Rogge describes it at this section of the video: kzbin.info/www/bejne/nZWaeq2FfNl5gbs

[@normcook9335]

Looking for info on the DXF tab (In version 24R / 2.8.4

[@kyleflynn4384]

I watched this section but he did not say anything about doing a taperd pipe thread where the thread shrinks in diameter as it goes deeper down the hole.

[@tormachinc]

Tapered pipe threading is currently available only on the lathe version of PathPilot, but not yet not available on PathPilot for the mill. It is on the list of future additions, but we can't promise exactly when it will be added.

[@niemdan]

Save some women foe the rest of us man!