Tractor bucket bent easy fix

How to straighten a bent bucket using a piece of pipe and simple tools.

[@raywmontgomery]

Can you use heat to ease the bend?

[@kencecil697]

Where is the video on fixing a bend in the front flange that you mentioned at the end of this video. I don't see it on your channel.

[@darrenmas]

@@kencecil697 for the cutting edge it’s the same process I used for the top edge. I think I did another video on the sides. Let me check for it.

[@darrenmas]

@@kencecil697 kzbin.info/www/bejne/hoCQeqCcjs2chqssi=bEvRjEJ3wHxvK1DO

[@gnburk]

My bucket's 3/4" cutting edge is badly bent. I doubt if even my 6" vise will straighten it. Any ideas?

[@darrenmas]

If you can email a pic to me I can give advice on easiest way. If it’s a bolt on edge most likely easiest way is to pull it and bend back with sledge.

[@Dean-yy6lo]

I couldn't watch but five minutes, you talk to much.

[@keithrev8896]

Wow, you talk way too much. Just get to it

[@350OK]

Seriously. Stupid shit