Traxxas X-Maxx rear differential ring gear and pinion replacement.

[@badfastbusa]

Well done video, thank you for teaching me for my first shredded rearend repair! Cheers!

[@Zippy247]

Your welcome thank you for your message.. 👍👍😎

[@RoadsideRC]

Good job on this video. I personally love how easy the X-Maxx is to work on!

[@Zippy247]

Roadside RC It certainly is an amazing truck to work on and thank you for your comment it’s very much appreciated.. 👍😁

[@SpeedSyko]

Lol I liked! Mine stripped after 5 years but first 800kv run. How to videos are great, thanks!

[@Zippy247]

Thank you for your comment.. 👍😎

[@macmccartney5760]

Just buy the Mobil 1 synthetic grease that's a pinkish red color screw all that expensive Traxxas grease you don't need it

[@Zippy247]

Thank for your comment i just use high performance grease 500g for under 10£$ because you are right Traxxas grease is an absolute ripoff and to buy 500g from them would cost hundreds of £$.

[@MrMan-ol4ic]

I noticed no shim's! Is it already shimmed or no? Is the diff tight no wobble or movement?

[@Zippy247]

Inside the ring gear and the differential housing there is a 1x rubber seal and then 1x plastic shimm and when the diff is reassembled it should feel hard to turn because of the diff oil. Hope this helps if you have any more questions please ask.

[@MrMan-ol4ic]

@@Zippy247 I appreciate the info brother. I'm about to buy an X Maxx and another 1/5 scale later. I've been watching a lot of videos and gathering as much information as possible.

[@Zippy247]

@@MrMan-ol4ic Your welcome and Traxxas has exploded diagrams of all there cars to help with repairs - traxxas.com/explodedviews/X-Maxx-8s-77086-4-Front-Assembly

[@xx_Mr_IQ_xx]

This was an awesome vid. Helped me get back on the road

[@davidseck1146]

What am I doing wrong if it works with the cover not being tightened down but binds when covered? I'm not even close to overnightening either.

[@Zippy247]

Hi if you have only taken off the ring gear then maybe the gasket is missing 9 minutes 24 seconds in the video also make sure the shafts holding the spider gears in place are crossing over each other smoothly it should feel like where the two shafts cross over that they are the same level.

[@davidseck1146]

@Zippy247 hi, I did swap the gasket over. Perhaps it didn't seat properly? I'll double check to make sure.

[@Zippy247]

@@davidseck1146 nice one let me know how you get on.. 👍😎

[@jimcobain4381]

Hi How stiff should the rear diff be? On mine the rear is much stiffer than the front

[@Zippy247]

Hi Jim the rear differential will be stiffer because it uses much thicker oil than the front differential and the centre differential uses extremely thick oil. When you turn your X-Maxx upside down you should feel that the front differential is quite loose and the rear differential should feel about three times stiffer to rotate.

[@jimcobain4381]

@@Zippy247 Thank you Fred for the quick response, that’s a great help, i thought my rear diff needed A good clean or something. 👍🏼

[@Zippy247]

Your welcome Jim glad I could help anything else you need to know just ask.. have fun.. 👍😎