How to Replace Front Wheel Bearing 2006-2011 Honda Civic

[@TRQ]

√ Watch the Video √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts √ Do it Yourself √ Save Money

[@diablo2815]

I took the lazy more expensive way out. I bought the loaded knuckle with the bearing already pressed in along with new ball joints.

[@aidena6138]

Please keep doing this, you are educating and helping so many

[@tiocruz1836]

what happened to the knuckle u pressed the bearing into? u installed a brand new knuckle with bearing and hub also when u pressed that bearing in u didn't put any grease on the bearing u installed it dry..... not to mention if I was resusing that rusty knuckle I would've wire brushed it and painted it with some corrosion reducer paint....

[@TomsCustomCreations]

Did you pull this car out of the Pacific Ocean?? So much corrosion! Done well to clean it up

[@user7xz38v4]

Anybody noticed that the wheel hub looks brand new at the end 🤔🧐

[@TheAed38]

How big of a hydraulic press do you need for this?

[@Fishing_4_Recovery]

Any chance you can make a video of how to change a bearing without a press?

[@TRQ]

+Fishing_4_Recovery We do not have a video for this repair right now, but we'll keep this request in mind for a future video! 1aau.to/m/Shop-TRQ

[@panagiotis1519]

Once you press (or hammer) out the wheel hub, TAKE OFF THE BACKING PLATE BEFORE you try press out the bearing otherwise you'll damage the plate & the knuckle! I'm so upset I damaged the thing, the bearing would not press out & I had the caliper bracket mounting points flex on the edge while in the press bending the upper mounting. Bad day!

[@9er4life67]

Thank you, you are a life saver

[@marvinurgel]

I am going to tackle this soon but a little confused on the removal of the sleeve from the old OEM wheel hub. Check out 13:56 , is that step necessary because when you remove the wheel hub, that sleeve if that is what is called will always be stuck with the wheel hub upon removal? if I get both new bearing and wheel hub, I do not need to do this step correct?

[@megaprimemaster]

The hub was not fine at 14:00

[@garyreams6248]

Where did you get spacer for bearing removal?

[@guirochulo]

Thanks , really was my solution your video ,

[@hellfire08]

How much should I charge to do this job 🤔

[@yvnggbeast528]

My guy has all snap on tools