How to Replace Front Window Regulator Assemblies 2003-2007 Honda Accord

[@TRQ]

√ Watch the Video √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts √ Do it Yourself √ Save Money

[@michaelduenas1364]

What if my window doesn’t roll down at all 😪 how do I get to the bolts

[@josephoneill3197]

One of the best "how to" videos on KZbin. The contributor was very thorough and clear on what to do and how to do it. His instructions on reassembly, often missed in other video repairs was concise and helped in not allowing missed assembly and ensured the proper hardware to be looking for.

[@pauliedogs]

I just replaced the regulator on my 2007 Accord. Because I watched your video (at least 3 times) when I was actually replacing it I felt like a pro and that I had done this many times before. The video was so well done that when I had questions I referred back to it during the replacement. It was very helpful and I saved myself at least $300 doing this myself. Thank You!! And of course, I subscribed 👍

[@mrau92me]

If ur window is stuck in the up position, I was able to use a 10 mm ratcheting combination wrench on both window clamp bolts. You can reach your hand through the access holes in the door and feel w/ ur fingers where the bolts are at the top of the regulator. Use one hand to feel for the bolt location and the other hand's fingers to guide the wrench on top of it. You can even see the fwd bolt thru a small hole. Once you get the bolt really loose, you can just unscrew it quickly with your fingers. I highly recommend having the ratcheting combo wrench for this.

[@faramir52771]

Thank you so much I thought I needed to take it to a shop to have this done . Part was 80$ with tax . Install took me maybe 20 min . Saved me a bunch of money .

[@timowens5870]

The whole purpose of the video is to change out the defective regulator. How do you expect someone to roll the window down to access the 2 10mm bolts?

[@nogal2002]

For those wondering how to get the bolts out in between the two holes without using the window switch to lower the window, I just manually lowered my window by hand and put tape on the window to hold the window in place so I could access the bolts. You should be able to freely move your window around to see the bolts

[@larryeaton9437]

My sincerest appreciation for the detailed instructional video. I have this EXACT SAME car and did the whole job in a little over an hour. Thank You !

[@jonathanbradley268]

Great video! Couldn't have asked for any clearer instructions. My son had been using duct tape to hold his window up until the part came. It took more time getting the sticky residue off than the installation. Thanks again!

[@BatMan-hu9qu]

Window doesnt go down with a dead motor. Here’s how I fixed mine. With my window stuck in the up position I could only push it down a couple inches. I removed the rest of the bolts to the motor and was able to push it down far enough to reach one bolt. I used a small 10mm combo wrench I was able to feel the head of the second bolt and reach it with the loop end of the combo wrench. Although I could only make 1/4 turns, once it was loose I unscrewed the rest by hand. Careful not to drop the wrench or bolt inside the door 😅 After that everything else went well.

[@NarpytheCrimeDog]

Thank you. I can't wait to make this take 10 times as long as you.

[@billtracyanderson1372]

Great video! Gave me the confidence to order the part and do it myself. Ours was siezed in the fully up position; we undid the bolts holding the regulator to the door anyway as well as the motor bolts. Once everything was a little freer to move, we were able to get a side-cutters in there (through the hole over the speaker) and cut the cable leading to the top so the window would drop. Just a little help in case anyone else runs into this problem.

[@38score17]

Just what I needed clear and well documented instructions thanks for sharing!!

[@OutcastCentral]

I installed the new regulator exactly as instructed, the window will roll up & down when I press the button, but eventually it'll just stop working, I originally thought maybe the window gets caught on something when going up & down, which it was at first but once I fixed that, I was testing to see if the window worked & it did for a few seconds than it just stopped working again. I'd unplug the regulator & plug it back in & it would work again but for a few seconds...maybe a defective regulator?

[@jameslee9191]

Best video instruction ever! I’ve watched many

[@Acostang0019]

Thank you for your detailed video I appreciate what are you doing , by now I a subscriber for ur videos ! ❤

[@nikstah1232]

Nice video man, me and my mate managed to swap my regulator for my Jdm cl7 euro r in about an hour and half, had its moments . But made it there in the end…

[@Danny-xk5wj]

Guy is a legend

[@jonathanmprince9764]

this helps a lot thank you

[@Reps562m3]

Very helpful thank you!

[@HyRkt]

Great Video, best tutorial ever

[@dannym5987]

Where purchased cat ??

[@scottfrasier156]

car locks have been altered as well as the auto window. disconnected the battery and waited, auto window returned. door locks... not

[@righteous1229]

Thanks very helpful

[@LexCanche]

Thank u bro

[@SashaNem]

thanks

[@Supreme408AI]

👍🏽

[@michaelperry3113]

So how do I get to the bolts since it doesn't roll down