How to Replace Fuel Pump 2005-2010 Chrysler 300

[@TRQ]

√ Watch the Video √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts √ Do it Yourself √ Save Money

[@matthewburt4771]

its a fuel pump issue so the car cant be turned on so how would i run it until it dies

[@noearvizu44pp]

Thanks for video, is very good explaining ,all the steps to install bolt pumps, GOD bless you 🙏

[@rubenbustos8193]

When you take off the fuel pump relay, and you said turn on the car til it dies out, what if your car doesn't start?

[@arshiealjohns931]

If you disconnect the battery why remove the relay too?

[@genebrown5219]

Wow! Thank you for sharing this information. I learned what I needed to know. Great working video.😊🎉

[@KJs581]

Great vid. I read the manual, but this is a lot more helpful. Thanks for posting!!!

[@osopolar6211]

No se ingles Pero solo con ver es mas que suficiente muchas gracias por enseñarme

[@bobbyagee3796]

300's have two fuel pumps a Primary and Auxiliary which is your filter. If your vehicle doesn't start, it is due to both pump and filter mechanism needing to be changed.

[@wildemarfreire5942]

What a work. Such a dangerous thing to do

[@thedonofthesouth]

At what point did you switch out the hoses tho?🤔

[@اصيلالاحمدي-ر6ت]

Dear, my question is: Does a 6.4 gas pump fit on a Chrysler 6.1 without problems?

[@bradleyguindon9119]

You should’ve mentioned in your video that if you disconnect the battery, you have to reset the steering angle circuit, which I now have to go to the dealership and have them take care of that which is gonna cost me money now

[@EstebanBurton]

this video was so helpful thanks

[@jrjacobo3031]

Do you know if they are compatible to dodge magnum ???

[@bigmikestan]

I wish you guys would have mentioned the fuel pump flange removal tool it's held to get it off with this method

[@BEAZY_5150]

Is this car actually needing the work done or is it just for a video how to?

[@CharlieBandz-r4l]

Thanks for sharing info 👍

[@DerekSilva604]

Thanks for the video, huge life saver! 👌🏼

[@sjjellema1952]

Great help this movie. Thanks a lot.

[@eugenelofton8087]

excellent tutorial

[@RafaelSanchez-w4h]

Por que sigue marcando mal el flotador de gasolina Si cambie la bomba completa

[@CharlieBandz-r4l]

Thank u for sharing info👍

[@jnimrtinz3101]

Where could i find the fuel line clip ? That goes on the main line ?

[@BrainDecrease]

You guys are the best

[@bobbyagee3796]

What about priming the pump?

[@RoMajor]

Fyi if you didn’t noticed this job is going to take ALL DAY! But good luck guys

[@angelamezcua3359]

I got that fixed 2 days ago and I think guy who fixed it couldn't put the metal circles that lock it in correct and smells like gas any ideas 2 why or is it cuz the metal seals didn't lock correct ?

[@TRQ]

+Angel We wouldn't be able to diagnose an issue like that here, you may want to have a local mechanic take a look at it. Thanks for checking us out! 1aau.to/m/Shop-1AAuto-c

[@aprilarnold132]

HELP>>>>Followed instruction and replaced fuel pump but then starter crank would not happen checked fuses they were OK. Took out battery? Charged it up still not start and crank? Have check tool says no codes.??????????? What could it be? Dash lights come on.

[@TRQ]

+April Arnold We wouldn't be able to diagnose an issue like that here, you may want to have a local mechanic take a look at it. Thanks for checking us out! 1aau.to/m/Shop-1AAuto-c

[@ronnieo6867]

Good job sir.

[@JWJTRAINOR]

Wouldn’t it just be easier to drain the gasoline from the tank then replace it and then just put the gas back in?

[@JWJTRAINOR]

There goes a few miles of gas on the back seat

[@RTTreyy]

Thank you!!

[@stevenphalin4957]

I came here to see if theses cars have a fuel return

[@billymcelroy2517]

Great

[@jamesmacdonald3090]

I have changed loads of pumps, if the car is "no start" you can't drain the fuel line and the steps in this vid are for changing a fuel filter not a pump? It is not advised to disconnect the battery on a 300c as they are prone to electrical/comms issues, removing the relay is enough or pay a pro to do the job. I let the pump drain for longer rather than spilling the contents over the tank. Easier to fit seals after the new pump has been connected, risk dropping it into the tank. Not a very good "how to" and very ham fisted.

[@tylerb3023]

Sounds a bit like Cecil from Invincible

[@User63416]

Your hands covering everything I haven’t seen nothing

[@jeffm8895]

Why not mention opening on a full tank is a bad idea. Why not tell how to know when the retention ring is seated.

[@Bigmoneyzeke]

Don’t buy it’s to long and float want work get from store original part number!!

[@CharlieBandz-r4l]

Thanks for sharing info 👍

[@bobbyagee3796]

What about priming the pump?

[@CharlieBandz-r4l]

Thanks for sharing info 👍

[@CharlieBandz-r4l]

Thanks for sharing info 👍