Understanding The X/M 32 Mixer Signal Path and Tap Points

[@АлексейПаутов-н7ц]

Hello from Russia! Thanks! Cool work!

[@DanaTucker1]

Hey, thanks! I hope you are doing well.

[@timtasker5724]

Thanks for this video! I'm kind of new to the X/M32, and this very issue was bugging me on the new M32 I purchased for our church. Coming from Presonus, there weren't as many possible options for both channel sends and bus sends. I didn't quite understand/ kept getting confused on the differences/interactions between the individual channel send taps to the buses vs the bus output taps which are on the Routing/Out 1-16 tab. I was muddling through with my bus settings for the last few weeks and this is very timely to what I've been trying to figure out.

[@DanaTucker1]

You are very welcome. I also teach one on one via zoom if you ever want to get up to speed quickly using the X/M 32 Mixers, as well as a few books I have written on the subject. danatucker.com/x32-rack-training/

[@savedandsoundmedia]

Great help 👊🏽 as always

[@DanaTucker1]

Appreciate it!

[@johnroesch689]

thank you

[@DanaTucker1]

You're welcome!

[@BastiaanRodenburg]

One question I'm strugling with: when sending inputs pre fader to my monitor buses, the CHANNEL mute is affecting this as well. However I want to be able to mute a channel front of house but have the artists be able to listen to their selves. Is there a way to do this with channel mutes or mute groups?

[@DanaTucker1]

No. The channel mute controls the input signal before it is sent to the bus, regardless of the tap point.

[@donm1547]

Hello Dana, Have an X32 C and want to use X32 EDIT but do not have WiFi, can I just use a Network Cable from X32 to Laptop? If so, any special config for this? Thanks, Don

[@DanaTucker1]

Not really, you just need to know the IP address of the computer and use a standard Ethernet cable, then setup the network in the mixer.

[@RockXMexico]

saludos desde México brother Dana!

[@DanaTucker1]

You are very welcome my international Brother and greetings to you as well!!

[@petterrong1590]

4:24 They are not affected by this selection, as send effects goes through buses and have their own tap points, as you show later in the video

[@DanaTucker1]

Ya, that's what I was thinking. It does not matter if the compressor is pre or post of the EQ, sends and returns will always come after the channel strip processing.