Upfitter switches 2015- 2019 Chevy Silverado GMC Sierra trucks

[@shorelinearmorllc477]

Do the plugs match for the back of the switches. ie backside of switch does traction control plug into new switch block or do you have to cut plug off and attach

[@willdaiss2598]

But where are you pulling power to run the accessory on the engine bay side?

[@RVing_TV]

Power is pulled right from the auxiliary box below the dash. It is connected to the main fuse panel that is in the engine bay. Hope this helps. Thanks for watching. Check out my fog light install video it explains more.

[@cadenbriggs4363]

Hey man, I have a Silverado and it originally had the two switch combo(traction control and cargo lights), than I bought the upgraded part with the AUX switches, the wires were there and everything. Do I need to add fuses in the fuse box because I upgraded the part, because the lights on the switches are turning on, but when I plug might lights into the right AUX pin in the box under the steering wheel it they don’t turn on. Please let me know what you think thank you???

[@RVing_TV]

I am not as familiar with the add on switches. I would check the GM outfitter website they have bulletins and information that should explain the set up. www.gmupfitter.com/ hope it helps.

[@MattBoss-zb9vn]

Where did you buy the upgrade part to add switches?

[@RVing_TV]

@@MattBoss-zb9vn My switches were factory installed. However, you can buy the kit from a GM dealer or gm parts online. The kit does look a little different from the factory switches.

[@thelongballhitter]

We're you able to figure this out? I believe I just ran into the same scenario, and am pretty sure it can't actually be done because the fuse and relay holders don't exist in the fuse box

[@cadenbriggs4363]

@@thelongballhitter i was not able to figure it out, i just ended up buying a switch pro. Where you able to figure it iut