Рет қаралды 61,536
How to perform calibration of the sunroof and sunshade mechanism in VAG cars (Audi, Volkswagen, Seat, Skoda). If the mechanism in your car is not working correctly, then you might need to perform adaptation procedure. You don't need diagnostic interface to fix it. You can start the end point learning procedure with this tutorial.
ℹ️ In this video you can see #Audi S6 C7 (4G) but the same procedure should work as well in Audi, VW, Seat, Skoda cars and the rest of the VAG group.
#Calibration / Adaptation / Basic settings / relearing of the sunroof and sunshade end positions is needed if:
➡️ single-click open and close is not working,
➡️ comfort open and close from the remote control is not working,
➡️ #sunroof stays open or the sunshade is not closing properly,
➡️ pinch protection is not working,
➡️ mechanical parts were removed and/or replaced,
➡️ roof control module has stored faults about missing basic settings or missing calibration.
💡 Sunroof / sunshade adaptation procedure is easy:
1. Turn the ignition on.
2. Press and hold sunroof closing button. In about 10 seconds roof will start to move.
3. Keep holding the button during the procedure.
4. When roof closes and stops you can release the button.
5. Press and hold sunshade closing button. In about 10 seconds sunshade will start to move.
6. Keep holding the button during the procedure.
7. When sunshade closes and stops you can release the button.
8. Calibration of the end points is done. You can turn the ignition off. Your sunroof and sunshade should work properly if there's no mechanical damage.
⚠️ Make sure that sunroof area is free of any obstacles. During the adaptation procedure pinch protection is not working. If there's risk of something getting trap in the roof window, please cancel the procedure.
✅ mr-fix.info/
✅ Facebook: / mrfixpl
✅ Instagram: / mrfixpl
✅ Pinterest: / mrfixpl