How to Repair the Thermostat of a Fuser Unit

How to repair the thermostat of a fuser unit in a laser printer or copier.
For any question or suggestion leave a comment.
- Activate the CC Subtitles in your language -
email: [e-mail]
other links:
www.emmegiricambi.it/
www.samsung.com/it/consumer/pc...
store.hp.com/us/en/cat/printers
www.brother-usa.com/printer/#....

[@Zodaz86]

Sir your video save me, this small thing nearly cost me a printer cause I wasn't gonna spend money and replace the fuser unit as it was in the thousands. Thanks a mil 🙏🏿

Thanks a lot. My Printer had the Error U1 2320. With Your viedeo I was able to repair it without any problem. Beeing not a PC specialist, I had to go to the dealer. Probably the dealer would have said: Buy a new one because my printer is 10 years old. So Thanks a lot for the video!

[@MichaelWilliams-ec5vb]

Thanks a lot that really helps 😊

[@alanz763]

Thank you, This advice saved me from trying to figure out where to get a new thermostat. I started to drill a 1/16" hole and it just popped out.

[@Zodaz86]

Omg thank you so much!

[@cavindrry9217]

Thanks a lot! There was only only problem odf thermostat in my printer and now after following your steps the thermostat is working properly fine! Thanks again!

[@zameerahmed1926]

THANKYOU MY PRINTER WORKING AFTER DOING SAME THANKYOU VERY MUCH

[@ersngltkn]

Great Work bro! Thank you so much!

[@durch99]

Thanks for your Video! Just for my understanding.... Through the bending of the plate the circuit is closed again, but will it cut the power again , if the temperature is too high, just like a new one would?

[@viandant5]

Yes it will work again

[@Giacee]

Ciao, hai un email alla quale posso contattarti?

[@viandant5]

la email è in descrizione