VIN Write for Ram Cummins 5.9L CM848 ECU using EDIAG form KingBolen

If you're in need of service or assistance:
-ECU Repair Services: keyworks.us
-DIY/Pro Resources: autoelectronics101.com
You can also support our channel by using our affiliate links below (also found in our comment replies), where we may receive compensation for your purchases:
-eBay : keyworks.us/lnks/ebay
-Amazon : keyworks.us/lnks/amzn
-AliExpress : keyworks.us/lnks/ali
If you'd like to make a direct contribution, you can do so via:
-Cash App: cash.app/$ecurepair
-PayPal: paypal.me/keyworks
Your support means a lot to us, Thanks for watching!

[@globalcommerce7654]

Hi, this is on all lauch based scanners. Its one of the reasons I use it as my daily scanner, ive got a video coming up on this topic.. it will however not change the vin but write it when blank

[@donwasse7892]

All you need to do is kill the power to the module during the read, then it will let you write the VIN even if it's been set before.

[@Fabi....]

👊👍

[@EkzdeeLFT]

find myself coming across this video after i swapped PDCs and got a chronic crank no start condition on the truck. No power to fuel system with key on, no key on power at fuel relay. I'm thinking i accidentally fed 12v to my ecm with no ground. Sound familiar? 05 truck.

[@ecurepair]

Hello, Its possible. Its common problem on those. Long as you made sure you matched the IPM with the correct part then it may be worth sending int in for a look.

[@toyotaworks09]

Any chance you can erase a skim on a 2007.5 ram 3500 ecm? I’m doing a 6.7 conversion in a 2002 excursion and I don’t want to tape the Ram key in a box with the skim and hide it under the dash I would rather just delete it. But I can’t figure out how to get me HP tuner to delete the skim.

[@ecurepair]

Yea I can usually do that

[@toyotaworks09]

I emailed your website, but haven’t gotten a response