HOT TUB Pump Seal and Motor Bearing Replacement

[@VIPPoolsandSpas]

We are getting very busy with KZbin and our video comments. At the same time we are trying to run a pool and hot tub business. Unfortunately, we will limit our comment responses to our Members. Consider becoming a Member: kzbin.info/door/7rBDbZ5XT4QtOouN6PTKXQjoin

[@ManNomad]

Was repairing plumbing on my spa turned off the breaker and when I powered back up, the keypad (TSC-19) lit up 100% all LEDs and never reset to normal operation. If I unplug the keypad, the pump, heater run. Plug it back in and same lit up keypad and everything shuts off, all leds on. Easy Pack EP1500CX1 controller (It usually resets within an hour but not this time. Is it a keypad? or the controller? Thanks

[@billwillis4402]

My pump is really loud, so I assume that I need to replace the bearings inside the motor. I also need to get a bearing puller. Mine is a Waterway Executive 56. Where can I find those parts?

[@VIPPoolsandSpas]

All the links for the tools we use are in the video description.

[@joefriday950]

Tganks for the video

[@ManNomad]

Was repairing my spa plumbing and when I powered it on - The keypad lit up 100% all leds solid and it did this before after an error but after about 30 min it started working. This time nothing reset and keypad is still lit up 100%. (Powered it off and on few times. When I unplug the keypad from the board the pump, heater start working. Is it a keypad (Gecko TSC-19) or the board/controller that is bad?. I do not want to buy a keypad if the bord is bad. The controller is an EasyPack EP1500CX1 digital single LED for the pump with the side color coded rectangular plugs.

[@VIPPoolsandSpas]

It sure sounds like the topside.

[@ManNomad]

@@VIPPoolsandSpas Thank you so much. I'll replace it and let you know how it went. Really appreciate you taking the time to reply.

[@VIPPoolsandSpas]

@@ManNomad all good.

[@Gooditalian]

Did you forget the link for the puller?

[@VIPPoolsandSpas]

amzn.to/3C1UhlM CANADA amzn.to/3C1UkxY USA