In this episode of the Raudi Metro Im fitting an MGF clutch pedal to the Metro pedal box with an OBP clutch master cylinder. / visionautogarage / visionautogarage
Пікірлер: 17
@SB-vb8ch5 жыл бұрын
Early (pre Verto) A series Metro used a hyd clutch. I have a GTM Libra which uses a modified K series Metro pedal box with an MGF master cyl.
@ProjectSupercar5 жыл бұрын
Yeah a spacer under the master cylinder should help line up the pedals, it would also help strengthen the mounting plate because it looks a little too thin and I think it may rip over time. VW's and Audi's have this trouble with the clutch master cylinder bending and ripping the bulkhead.
@VisionAutoGarage5 жыл бұрын
Yes, I definitely had that thought too. Although it's been fine for the brake master cylinder which has more force exerted on it for longer.
@ProjectSupercar5 жыл бұрын
@@VisionAutoGarage yes that is true, but the force applied to the brake master cylinder is spread over a larger area on the plate, whereas the clutch master cylinder is focused on a much smaller area. Plus the clutch master cylinder has maximum force applied every time the pedal is depressed, whereas the brake master cylinder only has light use, until an emergency stop is required.
@VisionAutoGarage5 жыл бұрын
@@ProjectSupercar either way, it's going to be reinforced with the spacer, better safe than no clutch on a hot lap :P
@ProjectSupercar5 жыл бұрын
@@VisionAutoGarage You got that right buddy, lol. :)
@Anderzander5 жыл бұрын
Good to see you sharing your humour 👍🏻😊
@PedalBox5 жыл бұрын
It might to look like we copied your OBP pedalbox, but we bought it just before this weekend, promise! :)
@VisionAutoGarage5 жыл бұрын
+PedalBox 😂 its ok, i bought that one two years ago for the v6 midget.
@PedalBox5 жыл бұрын
@@VisionAutoGarage Ahh, I do like the billet pedals, very nearly went for those but chose a Victory in the end.
@hedgerowe5 жыл бұрын
Are you going cleaning engine and bay.
@gregconboy80295 жыл бұрын
Seems like you made s lot of hard work for yourself there. You could of just used a mgf clutch master and welded a simple bracket onto the clutch pedal to suit. Half hour job
@VisionAutoGarage5 жыл бұрын
Yep, it wasnt really hard work and only took an hour or so in real time. But you are right, that would have been quicker and I may end up doing so.
@gregconboy80295 жыл бұрын
Honestly not to be negative but it would of been much easier. I can take you pics of mine if needed. It literally has a extra bit of 3mm slightly bent at an angle welded onto top of pedal and it's perfect. No need for a return spring either. You only need to drill out the centre hole and then 1 bolting hole because 1 of the original is used