WE GOT A TRACTOR! 1965 Massey Ferguson 202

Red Head Garage obtains a much-needed addition to the shop. A 1965 Massey Ferguson 202! The old Massey gets a tune-up and some much-needed maintenance. This old tractor runs but has no brakes, leaky hoses, poor electrical, and who knows what else!

[@mick2383]

I have a MF 1959 Gas Special, just finished replacing rear axle seal and rear brakes along with rebuilding the hydraulic pump. Replaced hydraulic fluid with 15w40. A must, replace your shifter boots people if you want to keep the water out of you hydraulics.

[@ACF6180T]

Thanks for the video guys; I didn't f f the video; I'm going to be doing all the gauges on my 1959 M-F 50, & the only one that's working is the oil pressure gauge. Mine doesn't have a fuel gauge, & it never had lights in the gauges, & the new ones do which I think will be neat once I'm done doing it. I like the humor in the video as well as the content. I rewired mine about 23 years ago when I put in a Pertronix electronic system but never did the gauges. I find your video very helpful. I'm going to sub. just to see the videos on the M-F 202 gasser. Thanks for doing this video.

[@redheadgarage]

Glad to hear it! Make sure to check out our follow up video! kzbin.info/www/bejne/rKjPgKNvmMpojbc

[@OldF1000]

Had the same problem with a 1958 Massy 65 steering wheel had to use a cutoff wheel to slice it off

[@mmnnbnvnbbgjgif9917]

غ

[@huwrichards9016]

Nice project. Never seen a petrol engine in one. Here in UK they are all diesel engines. Didn't even know MF used a petrol engine in those models. Must use a lot of fuel. 😱

[@mick2383]

MF 1959 TO35 Gas Special

[@cattoorsxsvlogs1239]

I got a 64 and need to know what to do to replace the clutch. I’m in a program that I have a shop with 12 bays that are open to me and need to know what to do

[@redheadgarage]

We have yet to replace the clutch in any tractor. However, the basics of it is it needs to be split in half typically. I would recommend looking for other videos out there such as this one kzbin.info/www/bejne/Y2mZeGiPhM6eY7M We wish you the best of luck!

[@philcovert1513]

Do you have another video on how you finished everything? I have to rewire mine as well.

[@redheadgarage]

Yes we do! In our follow up video we get the tractor back together and working. Also as part of an update since we got it back together: The tractor has been working great for a few months now with no issues!

[@JamesLee-ig3bu]

Question is how much it will cost one of these in bought today ? Does anyone know ?

[@redheadgarage]

We bought ours for $900 of Facebook Marketplace.