xTool F1 Galvo Laser With Slide Extension | Unbelievably Fast Laser Engraving!

This is a setup and review video for the amazing new F1 galvo laser from xTool.
The speed and accuracy of this machine is second to none.
This is a very versatile portable laser engraver that can even be handheld while engraving.
Think engraving on a vertical surface while holding the machine up against it.
Take a look and let me know in the comments of you have any questions.
If you are interested in any of the xTool products, I would really appreciate it if you used the affiliate links below.
Using an affiliate link will help support this channel.
Thanks a lot for watching!
Affiliate link for xTool F1
www.xtool.com/products/xtool-...
Affiliate link for other xTool products:
www.xtool.com/?ref=4a1SxtiKce...
Download xTool Creative Space Software:
www.xtool.com/pages/software?...
Download Trial version of LightBurn:
lightburnsoftware.com/pages/t...
If you enjoy these videos, please consider subscribing, liking and sharing this channel with others who might also enjoy them.
Thanks so much for watching. As always, I welcome any comments, questions or suggestions.
Follow Last Leg Woodworks on Instagram:
/ last_leg_woodworks
My Website:
www.lastlegwoodworks.com
Get the Freshest CA glues in the market at Starbond
www.starbond.com/?rfsn=441875...
Use Code LLWW15 at checkout to save 15% OFF on your purchase

[@terryclair2914]

Well done review!

[@mikeguidry49]

Week done video. Very informative.

[@fratre9683]

Hello, nice video! I have questions about the slide extension: Do I have to carry out the calibration every time the extension is installed and I use the F1 without it? and my 2nd question! If there are, for example, 4 coasters in the xcs, do I have to align them exactly and then measure exactly this distance on the extension and then align them? Sorry, I'm a beginner with the F1. best regards from Dortmund/Germany

[@ufoquilter86]

How does it know where to put the design without a camera? Do you set up a perimeter size for it to go by for the design?

[@dupescraftingdesign7872]

what is the setting for the cork coaster you did,

[@ufoquilter86]

When using the slide, you don’t put the cover down to protect your eyes from the laser?

[@johnnyditommaso6807]

real time engraving or are the speed up?

[@FASHIONALARMMODE]

No one can tell me the measurements of the biggest thing they engrave in the X Tool F1 engraver and cutter

[@airspeedaudio]

I think in another video i saw that it was 4 in x 4 in

[@carolwaller9605]

If you are adventurous and prepared to take the time to measure, tape off, do things in stages, then the only size limitations are your imagination and resolve. Where there is a will..

[@carolwaller9605]

The extension table is a bonus. Like with anything though, the work you are prepared to put in will increase the capacity.