The best part about this repair is no capacitors needed replacing; just a flaky surface-mounted component was eventually found to be the culprit. Once again, the technician's best friend "Mr. Acetone" makes a brief appearance. 😎Hopefully another happy customer as well! 👍👍
@bobbyk6585 Жыл бұрын
Amazing that you diagnosed that tiny regulator for the IC.
@welderfixer2 жыл бұрын
Great repair! Thanks for sharing.
@barryg412 жыл бұрын
I usually check first for visual problems then check for proper voltage. Nice work!
@jasejj2 жыл бұрын
Interesting one that, and one that would flummox a lot of techs I'm sure - i don't associate weird intermittent problems with voltage regulators. That's why you're a pro and I'm just a tinkerer 😁
@dpyles93962 жыл бұрын
Another great repair video! I always enjoy your repairs!
@leeselectronicwidgets2 жыл бұрын
Good that you could replace the chip without the usual AV receiver total tear down just for a simple part swap! 😄
@mixinginthebox2 жыл бұрын
Thank you.
@GadgetUK1642 жыл бұрын
Lovely repair =D
@davidringle1867 Жыл бұрын
Thanks 🙏 Brother...
@dennisqwertyuiop2 жыл бұрын
great work
@RPE98702 жыл бұрын
Well, I guess when you use the word “virgin” in your video you get some of these nonsense comments 🤦♂️. Great work as always!
@8bit_coder Жыл бұрын
I have an RX-A2010 that has a similar issue where the display gets sort of garbled after loud volumes until I restart the unit. Do you think it's having a similar issue?
@hugom11202 жыл бұрын
I bought the exact same receiver, faulty as well, for 25€ It would not turn on and go to protect mode, due to an incorrect power supply rail voltage I managed to byoass that security by adding a 10k resistor from the monitoring rail to ground, and it now works fine, except for analog video, but I don't really care about it honestly Maybe I'll try to find another board, but that doesn't seem to be an easy task...
@baguete02 Жыл бұрын
I have a HTR-3067 , I'm having a constant audio buzzing , coming from all the speakers, decreasing the front panel dimmer light lower the buzzing but I can decrease down to -4 only, I wouldn't mind to even turn off completely the front display light to get rid of this buzzing.
@radicalaudiodesign2 жыл бұрын
What fluid you use to clean off the flux?
@norcal7152 жыл бұрын
Acetone
@bones007able2 жыл бұрын
So if you did not have the IC you needed meant not fixable?...
@norcal7152 жыл бұрын
I may have used a fixed voltage regulator if I could not get the exact IC as replacement.