YZ450F Rebuild Series Carb Removal Part 1 (Barn find sitting for over a year and will not start)

Welcome to my 2007 Yamaha YZ450F rebuild series.
This Bike has been sitting for over a year and would not start. Picked it up for a project to rebuild. I usually work on 2 strokes however decided to try a new project.
In this video we pull the carb and find one of the issues causing no fuel to get to the carb. Full carb rebuild will be part two and we will take it from there. Going to do a full restore on the bike so much more to come.

[@alexr8895]

Did you make part 2?

[@DUE4IT6210.]

bs how did you get the cables off when you skipped

[@Maria523991]

Where is part two video?

[@johndennis2355]

When we getting part two man

[@frankiemarchese2978]

I cant believe how much work is needed to take the carb off of the 4th gen yz’s. On both my 01 426 and 05 450 I can get the carb out of the bike and apart in about 10 minutes. Same with the drain bolts. Weird placement on the 4th gen. The older the gen the easier it seemed to be to maintain at least imho

[@j.james-88]

Can we get an ETA on part II?

[@joshuaejackson]

Which side did you pull the carb out from? The part i needed to see was skipped😂

[@b4peeazy408]

fr

[@RazDann]

Pulled out through the back with rear spring removed.

[@RazDann]

Pulled through the rear with rear spring removed.

[@joshallred3388]

I’m trying to figure out the throttle cable😂

[@zackattack241]

Throttle cables????? 😂 skipped allot of steps bro

[@JumperXxXCables]

I couldn't hear what he was saying cause the music was too loud