Thankyou

Can someone help me. What holds the stub axle in? I thought it required a retaining clip so I bought one but I can only see that clip used on the passenger side axle and not the stub axle???

How fast can these leak? I cant get mine in the shop until after i get to a job site and thats 1000 miles away and im leaving tomorrow. How often should i stop to check the level?

Found out my dodge 2500 i just bought has a leaking seal. I topped off the rear, it took 1.5 quarts. I know I drove 400 miles since I bought the truck. What should i listen/look for to know if its damaged? What likely damage has occurred if any?

Hello, I bought a 2003 Cadillac Escalade 6.0 4v and this is my first experience with this model. Then I found out that in my country it is difficult to find a mechanic for this model, and I have to do everything myself. I want to order a repair kit for the front differential "USA Standard Gear (ZK GM8.25IFS-B) Master Overhaul Kit for GM 8.25" from Amazon, tell me, will it fit my Cadillac? Thank you.

I noticed ypu mentioned Randy's R&P are ypu located in Wa State? I'm in need of thos same service on 2010 8.25 front ifs

I noticed ypu mentioned Randy's R&P are ypu located in Wa State? I'm in need of thos same service on 2010 8.25 front ifs

you have to know how to disconnect trailer light plug or you will wrecki like ijust did

good job

Would have been nice to see how you put that "C" clip back on.

Why did you skip the part where you disconnected the transmission coolant lines?

Your video sux. You show no parts asy, where parts go, all I see is someone working on a pump.

Good job , what was that sensor under the intak manifold ?

Hello would you be so kind to let me no what color wires on the starter solenoid the small wires I have two that are disconnected and I don't want to put them in the wrong spot I just purchased this used

Lll

What are you using to scroll the dashboard menu?

777 pp😅. 00

Most helpful

Where did you acquire the oil cooler for an exact fit?

Where did you purchase the oil cooler, for the exact fit?

Thanks for the video. Any chance you have a part number for that sleeve and seal? (Maybe you shared those and I didn't see it?). Thanks for any help you can offer!

Thanks bud

Apparently even sensor safe slime needs to be cleaned off the sensor as soon a practically possible and cleaned off the inside of the tire when it is patched properly at a shop or if you can manage at home. Sensors are expensive and smog law now or something. Yeah, warn the tire guys about the slime. I have seen youtube of a really cool tire explosion. Must still be out there somewhere.

Quick question..does anyone know if you can buy gaskets for the front ..or must use RTV?

Thank you!!!! Owe you a cold beer or 2!!

Excellent !!! Thank you...owe you a cold beer!!

Thanks for taking the time to do this video. I have to reseal mine and this is very helpful

Helped me a lot, thanks.

how long did you wait from the time you replied the RTV change the time you put it on the housing and what are you estimate the torque that you applied to the bolts with the gun was?? nice video man thanks

Sick!

What a shitty video. List the tools needed.

What turbo you running

So when your ac was not blowing cold air, and the system was full of refrigerant, was your fan turning on when you turn on the ac from inside the car? I’m currently getting warm air, tons of pressure/freon, but the fan doesnt turn on when you turn on the ac and the ac clutch doesnt engage. The clutch was replaced two years ago, so i don’t think that’s the problem. I added an additional resistor to the low speed fan and scotch clipped it to the high speed fan wire (the high speed worked), but the fan still will not turn on when i turn on the ac. Could the problem be the compressor even though the fan wont turn on?

Looks like those liners were cut

Cual color de cable envia los 12 volts? Cual envia la tierra y cual envia los 5 volts?

I am about to tackle this myself. Ended up with an 01 Silverado that was lifted. Has a few little issues. Leaking front diff and 230k miles. Figure it is time for a rebuild. Also need to tackle the transfer case.

I can smell it from here.

I have fuel leaking somewhere on a mower I got for cheap. It's not in the gas lane so I'm guessing it's in the carburetor bulb. Thanks for the tutorial on how to change out the carburetor. 7 years later and you're still helping people with this video

I'm sure it is a great video, but the only problem is I went to sleep after the first 2 minutes. Zzzzz!

Where did you buy your parts brother? Great video but where did you buy all your stuff from?

Where can you find a kit like this to add hydraulics?

Where did you get your hydraulic pump re?Built, but I'm trying to get the whole hydraulic system.Rebuilt.So where can I send?Who can I send it to you get it rebuilt

Where you get your rear and front wheels?

Where did you order the seat cover replacement?

Video was interesting, but for some reason, I don’t see it as being as effective as a battery operated air cleaner for inside of the truck. The set up is much easier just turn it on no drilling holes no modifications needed .

I work on cars and try to my mowers. But guess I don't know too much. I have the same mower except no bag and the throttle is old style on the right with the cable connecting near air filter. And mine has springs on top of carb. This one seems to have none. I am trying to find out how they hook up and how many. And ideas?

Seal part numbers and where did you buy them?

Thanks man. Think I'm gonna give this a go on my Pilot. Great video.

Don't I need to bleed the brakes after replacement??

I have a 2018 Tahoe. The driver side stub axle has a bit of wobble and play to it. More then half of what I’ve found online says it’s normal. Even my local transmission repair shop said it’s normal when I called to inquire. It doesn’t feel normal. I saw someone say the “nut” that holds the bearing on the driver side can be adjusted once the tab is removed. Is this what you would recommend? Along with replacing the beedle bearing and seal? I hope this makes it to you. If there’s an expert in front diffs. It’s you. Thank you.