Were you doing the front or rear brakes? Is there a difference in brakes with 4WD? Is a 2007 Mercury Mariner the same process?
@MattStephensRich8 ай бұрын
These were fronts - would be same prices on the mariner!
@diyguy2383 Жыл бұрын
I have an 06 and this is build completely different than mine so idk htf that is
@drawingmac37733 жыл бұрын
Name of the brakes ?
@MattStephensRich3 жыл бұрын
Any will do. These were purchased from 1AAutoParts 😁
@docrobertc81293 жыл бұрын
I LIKE BOSCH OR RAYBESTOS,, RAYBESTOS #Mgd1047ach FRONT AND RAYBESTOS, #SGD1055C REAR, IF INDEED IT IS THIS MAKE AND MODEL YOUR WORKING ON
@MattStephensRich3 жыл бұрын
Good thoughts
@Clamjammer3 жыл бұрын
Use a jack stand please
@MattStephensRich3 жыл бұрын
Jack stand was indeed used ☺️promise the plastic bucket used for holding the brake caliper wasn’t used for any car weight!
@coryskow9783 жыл бұрын
Wow, I am a DIY’r myself and have replaced brakes and rotors many times. I was watching this video to make sure I had the right tools to help him replace them on his escape. However, if you watch this you will observe, at 2:30 there is a shot of the CV boot dislodged, then throughout you see the CV joint grease all over the rotor. How could DIY miss that? No wonder the breaks weren’t working, they are all lubed up. Not to mention the safety concerns. I do however appreciate the effort and success
@MattStephensRich3 жыл бұрын
That actually isn’t grease, but WD-40 that has been pre-applied. 😊
@coryskow9783 жыл бұрын
@@MattStephensRich My bad and I apologize for the judgement. Sadly I was watching the video again after my "S$%9" response, and realized the liquid must have been WD40. Go figure, I rarely post to videos and with yours I was completely wrong and again apologize. Thank you for your assistance, as your video was quite helpful. Most would attempt to delete their posts, but I will stand up to my error and, again thank you for your understanding and service.
@MattStephensRich3 жыл бұрын
No worries! Glad the video was still helpful. 😊
@fedor0797911 ай бұрын
My eyes bleeding :(
@MattStephensRich11 ай бұрын
Might want to get that checked out
@docrobertc81293 жыл бұрын
YOUR C-CLAMP, WHICH YOU CALL A VISE HAS A PIECE MISSING, WHAT YOU CALL A SLEDGE HAMMER LOOKS LIKE A RUBBER MALLET, SO YEAH, DON'T QUIT YOUR DAY JOB, I'M SURE I WAS MORE COMPETENT WHEN I WAS 13, WHAT MAKES THIS MORE THAN THE INCOMPETENCE, IS THE CONSTANT LAUGHING LIKE A LITTLE GIRL,, FYI, A PERSONAL PREFERENCES OF MINE, BEFORE REMOVING THAT OLD BRAKE PAD FROM THE PISTON, I WOULD COMPRESS THE PISTON IN USING THE OLD PAD, REDUCING THE CHANCE OF GETTING OIL OR OTHER DAMAGING SUBSTANCES ON THAT NEW PAD