Wanna change out the spark plugs yourself, why not try..Follow along it's not that bad..S7E294 Visit my store for Cool Merchandise teespring.com/stores/cuda-garage
Пікірлер: 71
@blairweatherby40902 жыл бұрын
Thanks for making this video. It was a big help when I changed the plugs in my wife’s Escsape!👍
@alyoungcuda2 жыл бұрын
Awesome..Thanks for Watching...
@vJofsy Жыл бұрын
Don’t forget to mention to use dielectric grease in the coil boot and anti seize on the plugs.
@alyoungcuda Жыл бұрын
If you noticed, on most cars that are from the factory, they have none of the above items on the spark plugs and boots but if you have them or bought them, it wouldn't hurt to use it of course...
@youkaidragon9 ай бұрын
@@alyoungcuda😊a!
@Bobby-ns7gn Жыл бұрын
Now on my 2013 I had to take a screw driver and lift the taps then pull the wires. As for the right two spark plugs I did remove the air tube, screws at each end of the tube and a hold down screw on the right side of the tube and was able to lift out. Just got to wiggle it a bit.
@alyoungcuda Жыл бұрын
Sounds good, thanks for watching...
@tonyrojas23573 жыл бұрын
Very helpful, thanks
@alyoungcuda3 жыл бұрын
Glad it was helpful!
@SummerTime256-e5p3 жыл бұрын
How do you remove the wires that are "around" the one on the right? I have not been able to figure out how to safely get the wiring unhooked... The wires on the coils are simple but those additional wires going to items into the engine block are hard to figure out how to release on my 2014 version pg the 2.0L engine.... Thanks.
@alyoungcuda3 жыл бұрын
You don't touch the other wires, once the air intake hose is disconnected the plug is all clear..I wrote it in one of the notes here in the comments..
@Chris-uc6jn3 жыл бұрын
In addition to replacing the plugs. Is there anything else you need to do to make sure they are proper and efficient?
@alyoungcuda3 жыл бұрын
Keep your air filter clean and every few months add a gas treatment and a water remover in your gas tank ..
@joymarslopez15583 жыл бұрын
I have escape too 2017 2.0 ecoboost, and I think it’s time to replace the sparkplug. What tools do I meed to used?
@alyoungcuda3 жыл бұрын
Basically what you see there in the video..a ratchet, long extension and a spark plug socket
@jerplane4002 жыл бұрын
Thanks for posting t his!
@alyoungcuda2 жыл бұрын
No problem, Thanks for Watching...
@vinceandtheresa12433 жыл бұрын
Wish you would have shown how you did the last one on the right. That tube on top makes it tough.
@alyoungcuda3 жыл бұрын
the one on the right you need to remove the clamp on the left of the intake tube and the 10mm bolt that holds the tube down on the valve cover and lift it out of the way towards the firewall and you will gain access to it
@SayMyName-cb2ht Жыл бұрын
shit is rtarded
@Ericzmusic-x4j4 жыл бұрын
Thanks I appreciate it video.
@alyoungcuda4 жыл бұрын
You welcome..thanks for watching
@JohnnyLawBMC4 жыл бұрын
Great, simple video. Lots of info making this a easy task. I’m at 100,000 miles for my 2016.
@alyoungcuda4 жыл бұрын
100,000 miles..wow got your monies worth out of those plugs for sure
@calisthenicsnoob99903 жыл бұрын
What tool do you use for the one on the far right? Not alot of space there
@alyoungcuda3 жыл бұрын
same tool, you make the space by moving the hoses over and the clamp on the intake tube gives you enough room.
@michaelwyant55412 жыл бұрын
I pulled off the cowl tray…popped off the wipers, some metal clips and 4 10mm bolts, 2 torx for mc reservoir….entire cowling came off in 5 min. Then you can easily get to the hose clamps for that air intake tube and lift it up enough to access the 3 and 4 cylinder. Make your life easy and remove that cowling….
@MrDavidelliottjr2 жыл бұрын
I did it woth out doing all that. They all seemed easy to get to for me.
@terf7020 Жыл бұрын
You can get to all four plugs while leaving the cowling tray in place. It's the air tube that really needs to come off, and you can get to the lower hose clamp screw nearest the airbox by popping off the battery cover, then you can (barely) get access to that hose clamp screw. The upper hose clamp above cylinder 1 is easy, and once that air tube is out of the way, just use different length socket extensions as needed to get the coil packs and plugs out. It also helps to remove the dipstick and oil fill cap, gives better access to swing the ratchet handle.
@davepinsent42023 жыл бұрын
Thanks a bunch.
@alyoungcuda3 жыл бұрын
You welcome thanks for watching
@TenTenFarms3 жыл бұрын
Thanks
@alyoungcuda3 жыл бұрын
No problem
@billmalec2 жыл бұрын
Coolant intrusion? All that orange on the plug. Especially it being number 2 cylinder there.
@alyoungcuda2 жыл бұрын
Thats way over 120,000 miles on those plugs..its all dry.
@666_Jesus_sucks Жыл бұрын
Very easy to DIY. Took me about 20-30 minutes
@alyoungcuda Жыл бұрын
Took me longer to video it..😆 thanks for watching too...
@666_Jesus_sucks Жыл бұрын
@@alyoungcuda man I believe it. I can’t believe I held off on doing it for so long. Very easy
@alyoungcuda Жыл бұрын
@@666_Jesus_sucks glad it worked out for you...
@joymarslopez15583 жыл бұрын
Hi what size did you used to take off the spark plug..
@alyoungcuda3 жыл бұрын
5/8 spark plug socket
@joymarslopez15583 жыл бұрын
Hi you did not finish your video to take off everything the spark plugs, how you take it off the number 3 and 4. I think it hard to take it off that spark plugs...
@alyoungcuda3 жыл бұрын
#3 & #4 comes out the same way..you need to loosen up that Solenoid and move the assy and hose out of the way along with the wire harness..its not that bad..
@joymarslopez15583 жыл бұрын
@@alyoungcuda Oh ok thanks it helps for me, do I need to take off the positive or negative cable of the battery before start the procedure or no need? Sorry for a lot of question.
@alyoungcuda3 жыл бұрын
No need to disconnect the battery
@user-rx5bv1bp4s4 жыл бұрын
what tools do i need?
@alyoungcuda4 жыл бұрын
Spark plug socket, at least a 12 inch extension and a Ratchet..all in 3/8 drive will work for you
@SethSetiadha11 ай бұрын
How many Spark Plugs are they? I read there are 4 of them. where are the rest of them located?
@alyoungcuda11 ай бұрын
4 and they are all in a row..you can see all 4 coils on top and they all look the same
@SethSetiadha11 ай бұрын
@@alyoungcuda thank you. I see that, would you recommend NGK ILZTR6A8G Laser Iridium Spark Plug (94769 Laser Iridium) ? is it good spare parts?
@alyoungcuda11 ай бұрын
ngk are great @@SethSetiadha
@davidjsouth2312 ай бұрын
It’s the same motor as a Fusion so 1-4 right in a row
@anant27543 жыл бұрын
My ford escape average / mileage went down what can i do
@alyoungcuda3 жыл бұрын
Tune up..replace your spark plugs,air filter, clean your throttle plate and go buy a bottle of injector cleaner, gas treatment and a water remover and put them in your tank with a new tank of premium gas..run that for a week..and check your air in your tires with a proper gauge
@anant27543 жыл бұрын
@@alyoungcuda dear Thank you very much, I did replace the air filter yesterday and bought spark plugs as well. I will buy all that and let's see the result THANK YOU
@anant27543 жыл бұрын
Hii, i replaced air fillter, cleaned injector by professional guy he said 2 injectors are leaking yesterday replaced both leak injector still mileage wont went up. Can you please help me.?
@alyoungcuda3 жыл бұрын
What's the miles per gallon you get now?
@anant27542 жыл бұрын
@@alyoungcuda 16L/100 KM it was 11 before.. I will drive one more week lets see the result
@davidjsouth2312 ай бұрын
Assuming it’s the same for a titanium
@alyoungcudaАй бұрын
If its the same engine
@davidjsouth231Ай бұрын
@@alyoungcuda my wife’s is a 2.0L ecoboost turbo
@haydartube10943 жыл бұрын
U should keep your wrench straight so u dont damage the spark plug wall...
@alyoungcuda3 жыл бұрын
You do realize this is for demonstration purposes since 1 hand is holding the camera but thanks for the tip for the others that have 2 hands..😆
@haydartube10943 жыл бұрын
@@alyoungcuda your welcome! Well, let somebody hold the camera for you..good video thou.