Thanks man, literally had 3 shops tell me they can't do it, but I see why they don't want to do it..
@GarageMahalLifeАй бұрын
Yes, and thank you for watching and commenting 😀
@gringopikachu Жыл бұрын
Retitle this to " how to take off the skid plate".
@GarageMahalLife Жыл бұрын
Right...
@TOPHiTTA2 Жыл бұрын
Theirs a plug just about a few inches above from the drain plug. That’s is the level/Fill plug. Fill until it over flows once it’s done spilling then you’re good 👍🏽 you can fill from the breather aswell but gravity feeding is a long procedure.
@GarageMahalLife Жыл бұрын
Good tip, thank you.
@rmjtalks6 ай бұрын
whatd do u mean? that black circular cap on the front of it? and if so, if ur filling the transmission fluid from the top obv do u have that black level fill cap open to see when it pours out when you should stop?
@vaidasl Жыл бұрын
Thanks, great walkthrough
@GarageMahalLife Жыл бұрын
Thank you for watching and commenting 😀
@bluesriderDF Жыл бұрын
I did this job today at home, 5th time I've done it. Add new fluid with car off, and side inspection port open. You can pour in three quarts without any gurgling. Then start the car and get it up to operating temperature for the last bit. Usually 3.5qts, give or take. Very quick fill process this way.
@GarageMahalLife Жыл бұрын
But do you measure how much to take out?
@bluesriderDF Жыл бұрын
@Brian E. Niskala I don't normally do the measure thing but this time I decided to do it. Three quarts plus one cup drained out. But the thing is, the fluid I drained was hot, and the stuff I put back in was room temperature. Trans fluid expands when it's hot. So you won't get a perfect replacement that way. But what you can do is overfill an extra cup, then take a ride until it's nice and warmed up. Then on a flat surface with the engine running, open the inspection cover and let it drain until it's a trickle, and then you know you are perfect.
@kennethdotsey52959 ай бұрын
Thank You
@CJr_M9 ай бұрын
There's so much conflicting information. This transmission definitely needs more than 3.5 quartz, unless you didn't drain it to complete dryness.
@bluesriderDF8 ай бұрын
@CJr_M 3.5 qts is about the max you can drain from it, unless you're doing some kind of vacuum flush. In a typical drain and fill on an automatic trans, you're only getting a portion of the fluid out. You can't drain it to "complete dryness"
@alexsantos58583 ай бұрын
Step by step. 👏🏼👏🏼👏🏼👏🏼👏🏼
@GarageMahalLife3 ай бұрын
Yes 😀 Thank you for watching and commenting
@finaljesus4 ай бұрын
i know this is a 1 yr old video but i didn’t know that there was a recall on the 2016 for the engine mine is at the dealership gettin one put in now it will take a month though so be prepared mine was wasting a lot of oil if this is helpful your welcome i’m in california by the way awesome video thank you for showing us how to do a transmission flush
@GarageMahalLife4 ай бұрын
Thank you and thank you for watching and commenting
@thetechman3366Ай бұрын
How did you get them to activate the recall? They refused to replace my engine and I have the same issues
@finaljesusАй бұрын
@@thetechman3366 go to the dealer I’m in California I didn’t even know they had a recall they told me so it may be different state to state
@thetechman3366Ай бұрын
@@finaljesus thanks for the reply. I’m in Florida, maybe I can find a state that will accept the recall
@finaljesusАй бұрын
@@thetechman3366 from what they told me it was a class action lawsuit I knew nothing about it lol and it took them almost 3 weeks and they had to keep it for a month but they did offer me a car rental which I didn’t get I’ll see if I can get some info too from your state I’ll call the dealership that helped me good luck 👍
@kennethdotsey52959 ай бұрын
Awesome and tricky procedure but I always wonder how in the factory do they fill transmissions and radiators because they don't have 45 minutes also how did you repair the broken bolts which is what is preventing me from tackling this job Thank you
@GarageMahalLife9 ай бұрын
They fill the trans prior to attaching the body, radiator kind of the same way, then they just top off. Broken bolts can either be removed with a vice locking plyer, that you grab the stem and lock it, and reverse out. Or drill into the bolt and use a reverse drill bit and or easy out. Do able...
@muhammadahsanaslam498411 ай бұрын
One of my friends got a transmission oil change but right after one week the gearbox got defective. What can be the reason before replacing transmission oil there was no single problem in the gearbox
@GarageMahalLife11 ай бұрын
So 2 things can happen... typically transmission fluid should be changed every 36k miles or per what the owner manual says. If it was a banded transmission cvt continous variable transmission there is a steel band, they break and can be just coincidence... traditional geared transmissions have a friction material on a friction plate. After so many miles, typically after 50 to 60k, this material comes off and can be suspended in the fluid. Usually the break down of this friction material happens if the old fluid is left unchanged and the fluid degrades and causes the friction material to start breaking down as well. So either of these 2 scenarios could have happened... so change your Trans fluid every 36k or as outlined in your owners manual.
@cuevas291 Жыл бұрын
Is 100k to long miles to change the oil? If you change it at that mileage, would you risk damaging the transmission?
@GarageMahalLife Жыл бұрын
Great question, 100k is a bit far, but no, changing the fluid is never too late, but earlier is obviously better...
@istvanraban Жыл бұрын
I have a question: Why do a lot of mechanics say don't replace the transmission fluid they said replace half of it??
@GarageMahalLife Жыл бұрын
Because a lot of people wait soooo long ro do this, it is almost not worth doing at that point, past 100k miles. So they only do half, because they are worried that any of the friction material from the transmission plates will become suspended in the fluid, rather than on the friction plates. Anyway... drain early like 50k or so...
@mookjdg5 ай бұрын
Swiss watch this whole video you're not sure how much it really holds and you don't know how to tell if it's full or not wow
@GarageMahalLife5 ай бұрын
No dip stick, measure what you drain... as I said in the video 😉
@mookjdg5 ай бұрын
@@GarageMahalLife I just asked Auto parts how much goes in there
@mookjdg5 ай бұрын
@@GarageMahalLife and there is a way to check it apparently you don't know it
@rmjtalks6 ай бұрын
so whats that black cirld cap that comes off too in the front of it? cause i thought that was where u drain it
@GarageMahalLife6 ай бұрын
The oil drain plug? What segment of the video?
@rmjtalks6 ай бұрын
@@GarageMahalLife its the transmission fluid level checker if u dont have a dip stick. the black circular cap in the front of the tank. i didnt know what i was but i figured it out. But thanku for that drain info
@anenca Жыл бұрын
I drain 3 quarters, should I put 4 quarters
@GarageMahalLife Жыл бұрын
Only put in what you drained out. So 3, if you think you had leaked, add make an additional 1/2 quart at most.
@hstone0808 Жыл бұрын
Four quarters, 2 dimes and a nickle
@jackievang33667 ай бұрын
If your still alive on KZbin please respond. What type of transmission fluid did you use? Im trying to do this by myself and dont want to spend 270 just for a transmission flush at the dealership. I drive a 2016 se.
@GarageMahalLife7 ай бұрын
I used this amzn.to/3TfeOwC
@jackievang33667 ай бұрын
@@GarageMahalLife thanks a bunch. Ur a life saver
@raidsalim699510 ай бұрын
How many liters of gear oil does a Sonata need? 2.4L 4 Cyl
@GarageMahalLife10 ай бұрын
5, but measure what you drain, put that back in that same amount.
@dougn235019 күн бұрын
The sad part is that it's not a complete transmission fluid exchange. So old fluid mixes with the fresh. Certainly not ideal.
@GarageMahalLife19 күн бұрын
You can dona dual flush, but the running temp difference is significant and saves the transmission over time.
@Societyyoumake7 ай бұрын
Where do you stick that tunnel at ??? I can’t see
@GarageMahalLife7 ай бұрын
It is the "transmission dip stick" right on top of the transmission
@edgarflores5045 ай бұрын
Is it safe to use valvoline atf on Hyundai?
@GarageMahalLife5 ай бұрын
It is always best to check what the manufacturer suggest, however, I've used Valvoline ATF on most trans jobs I have done.
@andresvalentin692410 ай бұрын
I have a car just like that. I changed mine at around 75K. I'm at 134K now. I will probably do it again soon.
@GarageMahalLife10 ай бұрын
It helps prolong the life of your transmission for sure
@fuelfilter Жыл бұрын
So there isn’t a transmission filter to replace?
@GarageMahalLife Жыл бұрын
Internal filter, requires trans drop and rebuild ...
@fuelfilter Жыл бұрын
@@GarageMahalLife Thanks Brian. I payed the 60 bucks for a months access to Hyundai tech. The procedure for a fluid replacement requires diagnostic computer to measure trans temp before checking for proper fluid level. I like your method better.
@aljaeautosales7447 Жыл бұрын
Nice video!!!
@GarageMahalLife Жыл бұрын
Thank you, thank you for watching & commenting
@aljaeautosales7447 Жыл бұрын
Also subscribed 😊
@AliKhan-ok6ph Жыл бұрын
How to measure the level?
@GarageMahalLife Жыл бұрын
Unless there is a leak, measure what you drain out and replace with the exact amount. Sealed system. However if there is a leak, it will make this a complicated process.