Affordable Bender for chromoly roll cage

Created by InShot
inshotapp.page.link/YTShare

[@scottnovak8903]

My old school finding center on pipe, I put same next each other ahold together scrape opposite direction leaving mark.

[@robertmccully2792]

Man i hate that dewalt steel cutter. I gave mine away, and i hate kneeling on the floor.. build a table with wheels and shelf below.

[@cumminscrawler]

What is the wall thickness of the CM? And 1 5/8" OD right?

[@ozarkmountaingarage6707]

Yes 1 5/8 but I don’t remember the wall thickness, sorry it was last year When I was building the roll cage

[@anoint426hemi6]

Your tool that's using the floor as a centering guide is all wrong. But your not alone. I see it on motortrend tv just about everytime there is suspension welded in and the car sitting on jack stands or on a lift. 1. most concrete floors are not level. 2. concrete has dips and using a guide such as yours follows those dips. 3. always check the concrete floor for level and dips before assuming anything. 4. better off fabbing a level platform even if it's a inch or two off the floor. 5. anything can be used, from metal to plywood. 6. rent a concrete floor grinder and grind away the unevenness and never have to worry about if your floor level again. 7. tell me to fkoff.