Airgun - Altaros regulator install to FX Royale 400

[@akungwelly]

Brother , my fx royal cylinder is not working, in mistakenly pumped up the cylinder more then 230 bar due to which something happened to th cylinder all the air inside the cylinder came out while pumping till 230 bar and since then it is not at all filling up the air even if I pumped it for an hour but the cylinder is not holding up the air .please give me a link as to what I should actually purchase ,please please advice with a link to purchase.

[@AirgunRegulator]

depends how much the cylinder was pressurized. By default, it should last more than 400bar. Most likely there is nothing physically damaged, but some seals have to be damaged that need to be found and replaced.

[@akungwelly]

Please help me how do I get the seal , can you help me with any link to purchase the seal.

[@akungwelly]

Brother I am from india and we dont have any manufacturers here so would be thankful if you could provide me with some link to purchase those seals.

[@akungwelly]

I know it has not been a major DAMAGE but the seal needs to be replace but I am confused is it the cylinder seal to be replaced or the air spitting compartment seal to be replaced . But most important I would like your kind help if you could help me out with a link to purchase those seals

[@AirgunRegulator]

@@akungwelly unfortunately I do not own this rifle, so I do not have a gasket overview. The basis is primarily to find out where the leak occurs. For this is the most suitable bottle, the pump is doing very badly. Then disassemble the part and measure the original seal, or contact the rifle manufacturer for information.

[@akungwelly]

Please answer me my freind