BMW N52 Engine Valve Stem Seals Replacement Part 3 of 3 | Detailed Assembly

In this video we are going to show how to assemble BMW N52B30 engine after valve seals replacement. Video includes intake and exhaust camshafts reinstallation. Eccentric shaft, rocker roller arms, return springs intermediate levers, lever roller springs installation. We will also install valve cover with new gaskets. Also we'll show how to properly insert valvetronic motor, VANOS adjustment units and how to reconnect all wiring. Vehicle in the video is 3-Series 2005 BMW E90 330i. This is the final part of three part video series on how to replace valve seals on BMW N52 engine. This engine was found on many BMW models like E90/E92/E93, E65/E66, E60/E61, F01, E89, E84, E87 and more! Procedure might vary slightly on other models but not by much.
BMW Flywheel lock pin tool code: 110300
BMW Camshaft timing fixture tool code: 114283
BMW Valvetronic Spring Remover/Installer tool code: 114270 or 117110
BMW Camshaft Bearing Fixture tool code: 114460
As an Amazon Associate, I earn from qualifying purchases.
Proper BMW engine timing lock tool kit: amzn.to/44doefX
Basic torque angle gauge tool: amzn.to/4bsPgCY
Small precise torque wrench: amzn.to/3jLzOvx
Big torque wrench similar to the one we used: amzn.to/3YY5aPT
Non-flammable brake cleaner: amzn.to/3vxXE0y
Disclaimer:
We, GK Works Automotive are not responsible for property damage or injury incurred as a result of any of the information contained in this video. Information provided in this video does not guarantee the desired outcome. Any injury, damage or loss that may result from improper use of the tools, equipment, or the information contained in this video is the sole responsibility of the user and not GK Works Automotive.

[@tomasis7]

amazing job!

[@tajnile5024]

my eccentric shaft is not rotating freely after tightening the bolts. Any suggestions?

[@Bharatbhum]

Aap kaha se ho mujhe sikhna hai

[@tajnile5024]

my eccentric shaft is not rotating freely after tightening the bolts. Any suggestions?

[@GK_Works]

Hello, we would suggest to recheck the installation to ensure all parts are aligned and seated correctly, inspect the shaft and bearings for any signs of damage or debris

[@foundinscriptureorg]

Turn your bmw ignition on with out true engine and step and hold the gas pedal for 30 sec that shoul reset it.

[@andreivs2257]

Did you solve the issue?