I purchased a 12 point triple square bit set. You can also look under XZN or XZN 12 point triple square bit set.
@DrCash711 жыл бұрын
Thanks man. Yeah I basically went off your last video (for the front breaks) opened up the back breaks, and got up to the part where the huge star bolt stares back at me. I'm going to order the bit set you mentioned in this video (and in the comments area :P ) but until the part arrives, how bad is it if I have new pads on old rotors with lips?
@esteban86819 жыл бұрын
Thanks for the video, saved my life here
@endsupremacy201011 жыл бұрын
When I get the chance, I will make that video. I'm due for an oil change anyway. I just have the Touareg off the road for the time being.
@DrCash711 жыл бұрын
Hey Cesar, what's the tool that you ended up purchasing off Amazon? I need to perform this on a 2004 Touareg. Thanks!
@rayrooney111 жыл бұрын
hey dude great vids, could you just do a simple service video oil filter that sort of thing for the touareg there is none on the net very odd.
@jackdemi857610 жыл бұрын
Thanks
@jeffersonwilloughby93110 жыл бұрын
I'm about to try this, and your video is an outstanding primer on the process. One item that I think might make disassembly easier (if I'm looking at the part correctly) is it looks like there is a parking brake tension adjuster attached by springs to the PB shoes. If you back that down, would it make it easier to remove the rotor?
@endsupremacy201010 жыл бұрын
jeff willoughby I would have to take a look at it, and it's been a very long time. I actually don't own the vehicle anymore. Sorry.
@jeffersonwilloughby93110 жыл бұрын
No worries. I did the front and rear in about two hours on my Cayenne. Still a great guide, keep up the good work!
@endsupremacy201011 жыл бұрын
I'm posting a link to the set in my video description.
@endsupremacy201011 жыл бұрын
Do not put new pads on those rotors. They will eat into the new pads. Your best bet is to leave the old ones on until you're able to put the new pads on. By the way, you might need a buddy to help you break those bolts loose. That & some WD40, that's what I did.
@poluboy10 жыл бұрын
good video, did you install those 2 screws back on the rotor?
@endsupremacy201010 жыл бұрын
poluboy Thanks. I actually didn't install the 2 screws back. They're not necessary.