Coin Ring Making Pro Tip #17 Swedish Wrap Tips and Tricks

Here is a handful of tips and tricks from ringers around the world. Learn what pipe tape I like to use, how to get a nice straight band, remove the pipe tape easily, center the plunger effortlessly in the die and more.
Swedish wrap dies available at :
JasonsWorks.com
RioGrande.com
Pipe tape:
1/2"
www.amazon.com/Oatey-15100-He...
riogrande.com
3/4"
www.amazon.com/gp/product/B00...
1"
www.amazon.com/gp/product/B00...
rubber o rings:
www.amazon.com/Neiko-50443A-A...

[@scottlay2970]

Just received my Jason works Swedish wrap die set will be trying it out today thanks for the timely service and very quick delievery

[@rworkman52]

Great tips. Love the O-ring tip. Thanks.

[@AC-fv7kt]

Great video....maybe one of your best videos....answers and helps a million questions or little problems that pop up. Thanks for sharing....I will be buying my tools from you going forward. Thanks for sharing

[@mikerussell6212]

After getting your swedish wrap die for silver dollars my rings are turning out perfect thanks for the very good video 👍 ring makers you need this die for Morgan's

[@willanski4321]

I love your videos man - so useful! :P

[@lemix69]

Thanks for a very informative video, I ordered the mega stretcher because I have had times when I needed to stretch larger, usually because I screwed up the coin. I tried extruding using the swedish wrap dies and came out with a size six. Didn't need a size six, so I stretched it back out and then reduced back to my size. It was pretty neat to see how that works. Thanks again.

[@rwhughes47]

EXCELLENT VIDEO AND TOOLS !!!

[@VansWorld]

Awesome thanks for the video.

[@johnpjoyce9687]

tks on tips on black O rings and teflon tape. ur th man..

[@perroblanco49]

I just learned that when wrapping the tape and applying coconut oil on the tape helps the ring slide down the die without the tape rolling up as you push down.

[@lindahansen4345]

Jason I need a pro tip on how to even up the sides of a coin if I made a slightly off center punch. Because the punch was off center the folding produced a wobble. I put the coin thru the swedish wrap and that's when I noticed that one side of the coin wall was larger than its opposite side. Is there a method to grind the non reeded edged of the coin down so that the wall is even all around/ Thanks

[@ricklevy1436]

awesome and i am all set to paypal ya just a question or two, great arbor press, or two?

[@karlseel815]

So, if I am understanding correctly, , If I had 5 SW dies small to large exit holes, using the middle SW die, if I extrude/push through a dollar coin for example, it will always be a size 8.. always. next size up we will always be a, say size 11. Then, on a push through, when the CUT side is flush with the bottom of the die, you FLIP it, reed side down, and then push it through... Am I close to being correct?

[@markcregger5878]

where can get the mega tape and how much, ordering the new punch tonight

[@dodgercan]

I I want to make a straight wall ring what die do I need for a silver Dollar?

[@trekranger]

Where do you get your silver coins ?

[@EverChan10]

Is it possible to get to a size 11 without the Swedish die? I have the 17° die.

[@josephlanzillo9680]

Bryan White

[@edbattista4064]

I been wanting to buy some of you ring tools but i can't found you on etsy

[@digdug8]

www.etsy.com/shop/JasonsWorks?ref=shop_sugg