Cross Drilling a Land Rover LT230 Input Gear - Project Daisy 9

Quick Video showing how you can cross drill old input gears to help lubricate the output shaft spline at home and save you a few quid!
Music from Uppbeat (free for Creators!):
uppbeat.io/t/fugu-vibes/spatial
License code: 1PPCZWHJCBJ3VTJ0

[@alan2804]

Tricky job that from the look of it, id be tempted to take it down the local machine shop and give them the problem, sometimes it can work out cheap enough but i like the idea of using whats available to us mortals to get it done. Just found your channel and enjoying it a lot.

[@mozsmancave2331]

I am a manual machinist by trade believe it or not 😅 but wanted to do it at home to show it can be done, glad you're enjoying it ☺️

[@alan2804]

@@mozsmancave2331 Well you're showing us all you dont need fancy expensive tooling to get the job done!😁 Especially loving the sheet metal fabrication on that bulkhead!

[@mozsmancave2331]

@@alan2804 thanks Alan! Means alot 😄

[@johnnywolde306]

Super! gonna drill mine as well, you only drilled 2 holes? are 4?

[@mozsmancave2331]

I drilled 3, it was fairly easy but I would recommend using a vice if possible