I just wanted someone to know that i appreciated the "baffled" joke towards the end of the video.
@DelkevicExhausts10 ай бұрын
Ha ha! Thank you, I couldn't resist including it :)
@MLZ19572 жыл бұрын
The question is, what if any is the effect on my motor if I remove the baffles from my Delkevic mufflers. want to make sure that I won't harm the bike's motor.
@DelkevicExhausts2 жыл бұрын
When we test the exhausts, we test them WITHOUT the baffles installed. Running your bike with the baffles installed is closer to running it with the OE exhaust, running without the baffles will allow an increase in the flow of exhaust gases from the engine, therefore helping to scavenge the cylinders better and allowing more fresh fuel air mixture to burn effeciently leading to an increase in power, in theory- obviously the amount depends on the bike and the exhaust.
@dmitry.demenchuk2 ай бұрын
do you make different baffles? for different noise limitations. thanks
@DelkevicExhausts2 ай бұрын
We only offer what we list on the website
@stuartcoopalnd6975 Жыл бұрын
I didn’t realise the van requires removal for the baffle removals. I fit and remove for different rides. Is it possible at all to grab the baffle from the end of the oval titanium can I have do you think please? I really didn’t want to have to keep taking the can off and on. The build quality is lovely fyi
@DelkevicExhausts Жыл бұрын
Hi almost all of our customers choose to either have the baffle in, or have it out and then keep it that way. We don't design it to be constantly removed and refitted and that's why on this exhaust, it's at the front. For things like spark arrestors etc. obviously they do go in at the back end so they can be taken on and off again easily.
@teachbhs Жыл бұрын
Is there a video on using the Delkevic re-packing kit?
@DelkevicExhausts Жыл бұрын
No, we don't have a video for that one, sorry.
@olivierr8243 Жыл бұрын
why the baffle is reversed on the titanium model. it is open on entry and closed on exit. is it more restrictive in this position? what is the reason, thanks?
@DelkevicExhausts Жыл бұрын
It was a combination of a few reasons, the way it fitted, ease of installing or removing it.... doing it the way we did just seemed to be the easiest way to do it and also we did find having the restriction at the front caused a hotspot to build up at the front of the muffler/silencer but this didn't happen when the restriction was at the rear of the baffle.
@mikejohnson9118 Жыл бұрын
1 No loctite (purple..blue) is recommended for the set screw?
@DelkevicExhausts Жыл бұрын
You can if you want to but it gets very hot, possibly hotter than normal loctite could endure. Using the screw dry will cause the metal to 'grip' a little and we haven't had a problem with them coming loose. You have to consider whether people will want to remove it again and how liekly they are to strip the hex round if it is too tight. You could use a dab of the gasket sealer supplied with the exhaust but again, it might be too much.
@rtroiani2 жыл бұрын
I’d like to quiet my DelKevic bullnose 16” on my 2020 Vulcan S. Any way to get a quieter baffle? They won’t respond to emails.
@DelkevicExhausts2 жыл бұрын
That is quite a loud exhaust to start with, it is relatively small with less packing material in it than a normal exhaust. If you need a quieter exhaust, we offer several different styles but they are physically larger. Please check the specs of the different exhaust on our website, the noise reduction figures are published on there.
@iamthelaw693 ай бұрын
Honestly, I wouldn't remove the baffle. Delkevic exhausts are loud enough as-is.
@DelkevicExhausts2 ай бұрын
Some people like'em a loud as possible :)
@davidanderson45002 жыл бұрын
will taking out the baffle on a stainless steel megafone delkevic exhaust on a kz1000 require any carb or other settings to be adjusted? or will it run just as good with or without the baffles?
@DelkevicExhausts2 жыл бұрын
HI, it will significantly change the gas-flow characteristics of the exhaust, and therefore it will affect how the engine runs and necessary carb setting. In the classic baffle removal video it is recommended that the Megaphone exhaust baffle is NOT removed.
@swordfish1120 Жыл бұрын
Are Delkevic slip-ons universal? Is the PP2206 designed for a specific type of bike?
@DelkevicExhausts Жыл бұрын
Hi, yes these silencers/mufflers are universal/generic, it is the link pipes and/or downpipes which are specific to particular bikes. However, they do have differing effects and some bikes prefer longer exhausts, some work better with slightly shorter ones as yuo can determine from the dyno videos on our channel.