DIY Fuse and Relay Panel for Accessory Power!

[@Wardy75]

Great video, thank you for sharing.

[@melvis2017]

How about the 85 ground from the relays you didn't wirre them to the fuse boxe.

[@WrenchAvengers]

i did. you can see later in the video i have black wires running to the bottom of the fuse block (black is 85 on my wire harness). i gloss over the wiring at about 10:14.

[@melvis2017]

@@WrenchAvengers am so sorry for that and I do promise myself not so much beer 🤣👍while watching something with electricity

[@WrenchAvengers]

@@melvis2017 lolol all good man. thanks for checking out my video!

[@2460speedy]

I dont understand why you removed the "red" wire".

[@WrenchAvengers]

lol sorry i didnt explain it well. on my wire harness the red wire went to 87a (middle terminal) on the relay. that terminal is not used for any devices i will be powering with the relays so removed that wire to keep the mess down as much as i could.

[@infamousnova]

What were all the accessories

[@WrenchAvengers]

handful of things that really didnt need this project lol. wideband, other guages, boost control, launch control, a clutch delay valve, and one relay set to switch ground signal to tell my ECU to turn on the rad fan. this made using the switches im using easier as the switches are all positive switching since they have LEDs so just made for easier cleaner install of all that. if i would ever get off my lazy ass i would get an updated video made with this in the car.

[@renhoek]

I took your advice and stopped watching the video.

[@charliespann3967]

To much talk and mug shot. Get to it bro.