Peugeot Expert P20E8 Pressure of the urea fluid too low fault fixed

[@nickayivor8432]

ACCOMPLISHED, DIYDALY 👍 From Nick Ayivor from London England 🇬🇧 ⏰️ 20:10PM Good Evening

[@Loftikaz]

Hi there, my urea pressure shows 6 bars but when engine off it goes to 4 bars immediately , it doesn’t hold the pressure it that normal?

[@diydaly]

I’m sure that’s nornam

[@georgiapratt458]

Where are you based do you offer diagnosis?

[@dapukire]

Every one can replace a part but only few can fix it.

[@warrenf1966]

Hi there, just some advice after watching your video: I have a Peugeot 308 2.0 blue hdi, 15 plate. Firstly whilst on motorway it started with the stereo said it was overheated and the volume went down from 29-15 and would go up( might be a thing) then 5 minutes later ‘engine fault repair needed’ then ‘ emissions control fault’ came up , car felt lumpy at 55 mph and shakey ( like wheel balance) but better at 40.break down came out and cleared P20E8, I’ve driven it for over 15 miles and no codes have appeared but still runs lumpy / out of sink, some say to clean NOX sensor ? What do you think… ps I am due a service 👍thanks

[@warrenf1966]

Wouldn’t go up stereo ok now

[@diydaly]

Very hard to say on that one without looking! Are there no fault codes? Nox sensors won’t cause it to run rough

[@warrenf1966]

@@diydaly thanks ; just done 60 miles no codes at present, I’m thinking if it was the pump on the adblue tank then the car would smoke. Just going to get a service and go from there thanks

[@FoodSEDUCTION]

Hi, would AdBlue Delete also fix this issue?

[@cw2126]

👍👍👍

[@diydaly]

Thanks mate

[@dapukire]

I thought he was going to fix the pump not replace the tank.

[@Tryingtimes007]

They all fail at “Mr Default” or time or miles 🤬