Doing this keeps my 8.6 Blackout Fed!

I doubt I’ll ever buy 8.6 Blackout factory brass after this 😂.
.
Please don’t forget to Subscribe.
.
Soon I’ll be back to uploading shooting videos. Weather here has us cooped up inside!

[@mockemperor953]

I'm going to assume most people who get recommended us will understand it but for the few who may not The brass after being used gets hard and around the end from the heat and pressure and you have to release that stressing hardness by heating it up for a certain amount of time so you can bring form it so you can put a bullet back in the brass

[@2A_CaliGuy]

Exactly! Soften the brass. Easier to form! If I don’t anneal them first I use the mini chop saw. What I’ve found is my annealed brass can load way more times!

[@cs7285]

Damn that 6.5 brass looks pretty just the way it is

[@2A_CaliGuy]

I know, and 6.5cm is a fun cartridge.

[@cs7285]

What did you set your anneal time to

[@2A_CaliGuy]

My annealer has speed rather then time. I took a few pieces of the brass I’d be using, and used tempilaq to set it. The dark room method also works. So far the brass is holding up great.

[@aamiraamir1023]

??????

[@2A_CaliGuy]

Can’t find brass/ammo so have to make my own.