Dsg adaptation on the Tiguan!

Short video walking you through how to do dsg adaptations on a dsg swapped Tiguan! It’s the same way you would do it on any other factory dsg car.
You will need VCDS or OBD11.
The steps must be followed in order as well.
Thanks for watching!

[@kikkegek]

nice video man. thanks. Im trying to do a "basic settings" procedure (as in your video) for my DSG6 transmission in my Seat Altea 2005 2.0 FSI. But for some reason my VCDS pages/groups dont match. I have a HEX-V2 adapter cable. my VCDS is version 23.3.1 (sop newer then the video). For some reaon my ATF temps are in group 008 and 010 and not in 019 like they show in the video. 019 actually just shows ERROR. Then I went into "basic settings" and looked up group 061 and it just shows ERROR. Neither are the other groups they mention in the video. What am I doing wrong? any ideas?

[@Turbojooe]

Hey dude. How do you determine if your software is above or below the one it specified other than it coming up error not available? Thanks in advance

[@user-yp6fz7ox7l]

I have 2013 CC, 2.0 TDI but I am afraid to do this. Is it very dangerous? I've heard bad stories. How does the adaptiation changed the behavior of the DSG.

[@cayden808]

Hey man do you think this would help solve the issue of my VW Eos jerking during acceleration only from a complete stop? This has become sort of my last resort to fixing this problem

[@prestofixit3518]

Sorry it’s doing that. If a fresh fluid and filter change and adaptation doesn’t fix it’s probably the mech unit going out

[@user-su1zt9qc5d]

After a DSG swap is performed.... Can it be tuned? And could this be done on a newer Tigaun/Q3?

[@prestofixit3518]

Yes I have tuned the dsg and the engine no problems. Not sure if it could be done on newer ones.

[@TiagoogaiT89]

Hi there, this is compatible for all dsg? 6 and 7 ?

[@prestofixit3518]

Wiring diagrames change for each dsg. Also different axels trans mounts. I know a dq500 7speed can be swapped and the dq250 6speed, that’s what I used and it’s been good!

[@yendys69]

Hello. Is same Procedure for when changing the mechatronic unit?