EIBACH | Pro-Spacer Installation Instructions System 4 | 8 (English)

[@joeyariascoots]

How often do I need to torque the wheel spacers after they are installed?

[@EibachFedern]

Hi, when you install the Eibach Pro-Spacers you only have to tighten them once with the Nm number prescribed for the car.

[@SureshYadav-cn6fs]

Very nice

[@bramoldenziel6373]

How many spacers are there in a package if i order on your site? Is it 2 or 4? And does it also come with all the nuts and bolts needed?

[@dnalor8753]

so if my ford mustang manual says to torque wheels to 150 ft/lbs, the spacer should also be torqued to 150 ft/lbs? feel like that's a little too much

[@philtroskey3454]

Very good information very professional thank you

[@Gedankenfrei]

nice 👍

[@Bitit2025]

Please advise, can i use spacer only for 2 rear wheels? Or does it have to be all 4 wheels? Thank you

[@leoabyssal4629]

Can be only rear or only front, or both, you decide

[@l.p.s]

Hello, I have a Peugeot 206, I would like to know if I can put wideners only on the rear wheels or if I have to put them on the 4 wheels of the car ?? Thank you. Bonjour, j'ai une peugeot 206, je voudrais savoir si je peut mettre des élargisseurs seulement sur les roues arrières ou si je suis obligé de les mettres sur les 4 roues de la voiture ?? Merci.

[@BuddhaOfDarkness]

Fitted em to the rear, but checked the steering afterwards!

[@nobbyhunt3438]

Leecifer Voorhees did you find them ok on rear only

[@BuddhaOfDarkness]

@@nobbyhunt3438 Sorry I was joking that the vid showed a rear fit then showed the steering being checked. I'd fit spacers to all wheels at once to avoid too much understeer.

[@rmmmodifikasi]

good uncle,,,

[@h-tuned6927]

how wide are the spacer ?

[@greg0716]

do i torque the spacers according to spacer specs or the original lug specs??

[@craftman5632]

I would use a little bit of blue loctite on each studs before installing the spacer, but do not add loctite on the spacer studs when you're reinstalling the wheel. Torque both the spacer lugs and wheel lugs to the factory recommended torque. I would recheck the torque on the spacer lugs each time you rotate your tires.

[@Casloveskim]

No, they are a litte higher the spacers are set at 140NM, the wheel lugs are like 120NM on my audi S3. But most important, use a torque wrench! The are cheap on internet bus very very helpfull, also if you want to release bolts.

[@The_Noticer.]

Why is there no video for system 6?

[@tevintomlinson4573]

What size tires are those

[@zeddecoration]

Good information?? I need like this for my g wagon

[@kofiaddo-frimpong140]

Do you have wheel spacer for Toyota Yaris 2008 model sedan.

[@SureshYadav-cn6fs]

Yes

[@guillermoverde81]

@@SureshYadav-cn6fs for lexus gs 430 2006?

[@bencrosbie]

whats the nm for vw

[@steffilawbei1463]

front and back wheel spacer are same size or different size

[@Whiskeyactual9531]

Stud patterns will be the same but width will vary. I'm running 15mm in the front and 25mm in the rear.

[@clesiorogeriolauriano9694]

KiA soul pode ?

[@neillindsay4568]

Torque spec???

[@zumabilla]

I just discovered the wheel nuts on the Pro-spacer threads need to be a damn sight higher torque value than standard car manufacturers recommendation or they work loose very quickly. Eibach did not tell me this at purchase or in supplied documentation. Safety critical and a potentially dangerous situation in my opinion. I have reached out to Eibach GmbH for more information and explanation. I am still waiting.... 🤬

[@zumabilla]

Pro-spacer to hub (manufacturers recommend torque value) using special Eibach nuts supplied. In my case 170Nm Then wheel to Pro-spacer torque 200Nm using original wheel nuts. I'm not sure I will be keeping them on the car. I am monitoring wheel nut torque weekly to be safe. Not ideal.

[@lucc7116]

what about an before and after

[@adrianscott8317]

What is the spray the lad uses

[@turboman6680]

Brake cleaner

[@ANKURCARTECHNICAL]

Tata Indigo ecs me lag jayega kya

[@vinodsao4465]

😂🤣

[@danelvelez597]

Pregunto busco spacer para fiat 500c 4/98 to 5/114 precio y si los tienen no mas de 1/2 pulg.para fuera

[@mohamadcherqaoui9824]

Toooop

[@bmwmpower4717]

hi I want to go your spacers, but is it true that they ruin the wheel bearings?

[@byOrbaa]

what supplied nuts are they never recevied them

[@ing.martinz]

hola para ford ranger wildtrack 2020 y quiero poner espaciadores sutiles que no salga mucho que quede justo en el limite de la carroceria que medidas tiene que ser? Yo habia pensado 25mm adelante y 20mm atras .... esta bien?

[@brunorodriguez6234]

If the spacers don't sit right in the disc is it ok

[@craftman5632]

If the lug nuts are Cone shape that is supplied with the spacer, it should self center itself on the hub.

[@chicozeruela6255]

Tenho uma Kombi ano78 quero colocar roda do golf

[@noynoy3190]

Looks the same as stock ones no different. The tires Suppose to stick out and show more

[@noynoy3190]

@TAINBROS Whatever you say Mr so cool. Ain't shit Talk like your damn cool. Bit**

[@noynoy3190]

@TAINBROS That's right keep your stinky ass mouth shut. Can't laugh now huh? Shit bag

[@iambur4k831]

Türkiyede Nerede satılıyor?

[@ayssarmkss9506]

FORUM

[@34KDR58]

eibach türkiye

[@imrausniimra510]

Untuk jimny

[@chicozeruela6255]

Quando é esse adpitador

[@puguhmagetan9587]

U