Fernox TF1 Filter Service & Maintenance

Kevin Shea, of Emerson Swan, demonstrates the Fernox TF1 filter, goes over servicing the unit and explains how it helps prolong the life of your hydronic system.

[@viko2273]

An educating one. Thanks a lot from a Hungarian viewer. As you disassembled the filter air should have been vent out trough the top shiny screw on the top. If you just release the magnet to let the dirty water out it is fine not to air vent as the system remains air tight.

[@Tampo-tiger]

Just excellent, thank you very much from a UK viewer.

[@delwalker6336]

Thank you!

[@unboxmeuk]

I spoke to them directy and theses comments below are not right, You did it right, You do not need to one the top for cleaning. only the bottom.

[@mastard780]

Shouldn't you vent the air out from the top of the TF1 before opening the exit and supply valves? I loosen the flat head screw to allow air to escape and then crack the supply valve to fill the TF1 until a solid stream of water comes out. Or do I just let my auto vents do their thing?

[@deanosborne6037]

Great Video, however, the air should be vented prior to opening the filter back to the system and the top can be unscrewed for 2 reasons. 1, Cleaning and 2, For dosing the system with inhibitor or cleaning agents etc...

[@peggy3377]

Hi,when yo start clean tf1 filter you need turn off all system?

[@ChristianBower-sz6qi]

Can you add system inhibitor through the TF 1 ?

[@MaterialSquid]

thanks for this

[@florinadrian5174]

2:10 You did something at the top of the filter which wasn't in the frame. What?

[@johanna4nails424]

I still have a leak after cleaning my filter 😬

[@davidgeorge6382]

kevin you made it look so easy can you come round and show me again only joking great job thank you

[@milanduro5721]

you forgot to vent the filter at the end

[@sebmeister67]

in the manual it shows that the draining is done with the valve above the filter, you've done it with the one underneath. which valve should i open and will there be any air stuck in the system?

[@geraldbrown2840]

I have always thought that the instruction manual shows using the wrong valve!

[@onlyme972]

Top valve open would drain from your boilers pump or heat exchanger. Better to use the bottom valve.

[@petersharpe742]

Why do Americans drone on and on, taking hours to tell us what can be explained in minutes.