FIFO Depth Consideration in synchronous and asynchronous FIFO. For non powers of 2 . (CDC)

FIFO depth consideration is explained , if you have any doubts please feel free to comment below , I WILL ANSWER YOUR DOUBTS WITHIN 24 HRS.
Thanks for watching , PLEASE DO SUBSCRIBE , IT WILL HELP , ME A LOT.

[@DD-sm2gz]

Keep sharing your knowledge. Thanks in advance!!

[@KarthikVippala]

Thank you for your support 🙏

[@anilkadiyala]

thanks for the video. if possible, make a video on the cdc methods when fa > fb and fa < fb.

[@KarthikVippala]

Hey anil thanks for the feedback , I have made videos on CDC methods , you can check out the playlist synchronizers in my channel.

[@DD-sm2gz]

Thanks for this!!

[@KarthikVippala]

Thank you for commenting , 👍

[@KarthikVippala]

Hey DC , do you need any specific topic , if I know that topic I can make a video on it for you👍

[@DD-sm2gz]

Yes, looking for amba protocols, all possible configuration in each protocol with timing diagram. If u have videos or study material in any other form please share.

[@KarthikVippala]

Amba bus is slightly a big topic(AHB) to explain in a video, If you want to read it , start studying from spec sheet , go for main signals (around 50) , know what they do .Be patient in the process .If you have doubts in them feel free to comment 👍 Spec sheet is available on internet .

[@saravanakumar7290]

Thanks a lot for the Video Karthik, If possible can you make a Video on Basic overview on synthesis process containing basic syntax of constraints and techniques to overcome synthesis issues (e.g Slack, Multi cycle path)

[@bhoomikasbidari3936]

Sir , Actually there are some cases regarding the calculation of Asynchronous FIFO based on write and read frequency. Can you explain those in a video? Also , When do we use a synchronous FIFO b/w devices and when do we use an asynchronous FIFO b/w devices? Give some examples. None of the video's are available. Like how you've given the explanation about the Asynchronous FIFO please do the same for Synchronous FIFO.

[@KarthikVippala]

Sure will do

[@charankatamreddy6813]

What if FIFO DEPTH IS NOT DIVISIBLE BY 2?

[@KarthikVippala]

Hey charan thanks for asking , for such cases , it will be better to convert the depth to divide by 2 Say depth is 311 , 312 will do the work , only one extra depth won't cause you that much trouble in the design . Good luck, good health 👍

[@prathameshchodankar5131]

This does not work always. consider FIFO depth 24 and try. we end up with 4 to 28 pointer values. but if you see wrapping up from 28 to 4 changes 2 bits (which was supposed to be just 1 bit). can you check & clarify ?

[@Ajay-mw3or]

pointers range is 4 to 27 . so 1 bit change.