Fox Body Mustang Wilwood Brake conversion.

[@dlb4109]

Good old Fort Bragg and Pope AFB 🇺🇸. I’m from California but live Harnett County. The Foxbody scene is nice in the Southeast.

[@curtismccombs2212]

I would 100% let you work on any of my mustangs!

[@seeunow44]

Can you provide description of « the right tool » used to tap for brake installation…. Appreciate your content…. Very helpful !!

[@robturner7853]

Most of these are drilled 5/16 then tapped with a 3/8-16 tap....The brake kit you buy will have that info, usually on the 1st page .

[@jdrods1519]

Awesome!!! 🇺🇸💪🏼

[@alltherpm]

Did same to my front had no issues and fit great, it's on my channel as well

[@Petraeus_95]

Beautiful

[@michaelhogg7241]

Hey man i got a question on brakes ...oh by the way long time subscriber love love your videos..re done all my brakes had lost in pressure so I'm thinking i need to reset my proportional valve..how do you do that...i have brakes in the front no fluid getting to the rear..sorry long read

[@robturner7853]

Its a pain to do alone for sure , main thing is adding fluid to master cylinder as you bleed front to back . If the fluid gets to low its going to pull air!!! And at that point you need to restart the entire process "in my experience" anyway..hope this helps GL

[@sean6049]

Would i be able to install a wilwood master cylinder on to the stock brake booster? i have similar setup

[@natejones689]

Need an update on project Phoenix

[@foxjunk73]

Coming soon!!!

[@dustinrogers6219]

Did this set cause the tire to push out any? I am wondering if it has the same offset as factory. My current setup would not handle my tires to push out any further.

[@foxjunk73]

@@dustinrogers6219 no, seemed to have the same fitment

[@dustinrogers6219]

@@foxjunk73 Thanks for the quick reply. I did a little more digging and it seems to say they may have a positive .24 offset over stock. I cannot verify that for sure but wanted to know if you saw a difference on yours.

[@CCWFOX]

Any particular reason why he chose that kit versus others that don't need that much modification?

[@foxjunk73]

Cutting off 2 small pieces and tapping a few holes isn't very much to modify, plus for $800 for the full set, that is in line or less than any good 5 lug front race brakes.

[@thruitallauto2538]

So you think hand tight on the wheel bearing is ok ,verses the 200 ftlb it calls for on stock

[@foxjunk73]

​@thruitallauto2538 this is not a sealed bearing type hub like found on 94 and up cars, this is the proper way to tighten this type of wheel bearing.