Generac low oil pressure

[@patricksp71]

THANK YOU saved me from a 300 service call, replaced and it fired up and no problems, Wish I could leave a tip for you

[@donovanwilliams4545]

Thank you sir!

[@randallm06]

Thanks I have same problem 16w I put oil and was licking from the part

[@rockwilliams457]

What size Generac do you have? I just got a 22kw, and am installing it. How long did you run it before you had this issue? Are you running synthetic oil 5-30? Thanks for this...

[@aswitzer3895]

Motor oil is motor oil. Had it for 3 years prior to this issue.

[@mickeyflanagan4019]

Can i unplug it to bypass it just to see if that is the problem?

[@TheChefef]

I had the same error code bought a new pressure switch installed it same thing it only runs for a minute and stops same code ,turns out to be a firmware update needed I’m going to try that next mine is a10kw

[@stzsurge2250]

Yo it's me brendan your neighbor! :)

[@aswitzer3895]

On Brewster Dr?

[@stzsurge2250]

@@aswitzer3895 Marblehead Dr.

[@chriscales32]

How would you bypass this switch if needed?

[@aswitzer3895]

Splice both wires together that would normally connect to the sensor. You risk damage if you actually lose oil, though. Probably only a good idea in an emergency until you can get a new switch.