GlowShift® Fuel Gauge Installation (for Fuel Cell)

[@johnbarbina6675]

I no you have had this video out for a while but you just helped me out so much those fuel cells with sending units don't have a diagram for the wiring as well as how to hook it up so thank you again for the info

[@notone4029]

Thanks so much for this video!!!🙏🏻🙏🏻🙏🏻🙏🏻 Excellent job explaining!!👍🏻👍🏻

[@joeoliver9223]

Installing all my gauges and could not get the fuel sensor to work.....well I feel like a fool not realizing one of the wires from the tank have to be grounded also....I hope this solves my problem. I like the gauges from this company, especially the option of changing colors. You are correct you need constant power on the yellow wire so the gauges remember the color you set them at......thanks for your video Joe

[@hamishconstruction]

you have help me as the enclosed instructions where hard for me to understand. I did pay full price and I am happy. the dial needlel moves 3/4 around the dial, not just 1/4 as most. I like it and all the colors. installed in my RV.

[@geethangbaby9]

If you get a reading after you hook it up does that mean the ohm setting is correct?

[@jesus5.774]

Helpful video

[@storman7609]

Thank you

[@mamalonaobs]

I installed mine and when I switch on ignition it doesn’t move. But when I switch off ignition it moves to the reading before the gauges turn off

[@Syrus54]

Wired it up wrong. Check the wites again. If theyre GOOD, then its defective.

[@mamalonaobs]

@@Syrus54 I connected the gauges how they’re supposed to go because my other 2 work fine. I found my signal wire and I had tapped into that and it wasn’t working it was going all the way to full. I had tapped into my ground and it would mark empty. So I tried tapping my ground with the signal and it would go to full. And when I don’t have the signal wire connected to the fuel signal it marks how much gas I have according to my gauge cluster.

[@PhilipGragg]

Subscribed because you have a sick yota haha... How do you like these gauges? I need another oil pressure gauge..

[@Syrus54]

I think these gauges are overpriced. $30 would be a fair shake.

[@caballeroix]

where did bought it?

[@Syrus54]

Amazon

[@ericsanchez3566]

Will this work if my gas gauge from my cluster dont work and i try putting a gauge in it instead? Or it still wont work

[@mamalonaobs]

Did it work?

[@jahon56]

How do I find out ohms?

[@Syrus54]

I called up the people i bought my tank from. If thats not an option, fill your tank to the top, play with the settings until it reads full tank.

[@tylerseabook9423]

Why wouldnt you just hook the sending u it ground to the body in the trunk. Zero point is running a ground to your junction box

[@Syrus54]

Key phrase would be a "GOOD" ground.....