GREAT GIFT FOR TRAILER OWNERS! GENY Snap Latch Coupler!

[@Itsa_Mea]

I would of liked to have seen a grease fitting for the ball release shaft and internal locking pin mechanism.

[@mtpowder8974]

With employees who Will undoubtedly back the ball into the side mechanism I don't see this holding up long-term. Keeping locking mechanisms on top prevents damage happening from that instance.

[@GovG33k]

There’s two more holes under that coupler. If someone wanted to mount another coupler under it and steal your trailer… they could. Just a thought.

[@operationhotshotinc.6887]

if someone wants to steal your trailer bad enough they will

[@olegig5166]

Those holes can be cheaply protected by inserting a lockable pin made for 3" receiver hitches.

[@gizzmo2875]

Are there any coupler locks that fit this unit yet??

[@olegig5166]

I note the degree you have gone to secure the bolts. Why not just replace one of the bolts with a 5/8 locking pin made to secure any insert into a 3" receiver?

[@BTBRVReviews]

That's not a bad idea. However, there are torque specs on channel bolts for couplers. That would have be believe (possibly incorrectly) that they should be tightened. Good point though

[@HalfPint5811]

Venison of the sky.....

[@i70show]

?