Dismantling an aluminium and glass greenhouse. How to remove and re-assemble again. This one is 8x6ft, made by Eden.
Пікірлер: 78
@nicolaelson50444 жыл бұрын
Just about to dismantle a greenhouse, it's very intimidating, thank you so much for this, I feel more confident about it now!
@malcolmfoster5744 Жыл бұрын
I knew nothing about greenhouse construction until watching this very helpful video. My son, who handily lives next door, had a 6'x8' Eden greenhouse he did not need, use or want. I grew some great Alicante beef, and Roma plum tomatoes in it this year, a pepper and cucumber. It also had a fruiting grapevine inside, some 40+ years old. I have 'adopted' both. With 50 panes removed (none broken!), my wife and I lifted the whole frame, minus door, over the 5' hedge (not bad for two mid-70's OAPs, photos to prove!) and it now sits on its new flagged base. Seals out, moss removed, wire brushed then pressure-washed, glass cleaned, it will look great. I re-planted the vine outside this time to go in through a bottom corner, hoping it will survive. Just door, window and glass to replace - and the missing door runners! Yes, a window-fixing bolt sheared but will swap for another where a normal bolt will do. Many thanks, Mike, for the time and trouble taken. Great job - basically 🙂
@mikeb1043 Жыл бұрын
Hi Malcolm. Thank for sharing that. Really nice to hear the video was helpful. Good luck with the tomatoes - sounds great! Cheers - Mike
@malcolmfoster5744 Жыл бұрын
@@mikeb1043 . Hi Mike. Thanks for the reply. Yes, what I learned was very useful. Glass all fitted, I have just completed insulating the insides with (large) bubble-wrap to extend the growing season. I hope to try my 80W caravan solar panel and leisure battery with a new 12V heater. For fortnightly caravan stays, I made a home-made gravity water irrigation system with a £1 B&Q bucket and spare 4mm pneumatic tubing drilled. 🙂. I hope to get off to an early start, some things already started, like garlic and broad beans, Also 3 mushroom growing kits on the way. I just have a problem trying to source two replacement sliding door rollers (about 7/8" dia x 3/8" wide, with 3/8" bore) which are completely missing, just the studs left. All I can find have a radiused groove on the outside and mine looks to need a male 90 degree vee profile to match the female vee'd track runner. May be obsolete now, but will make/have made if needs be. Looking forward to next year, Best wishes.
@nigelhunter42303 жыл бұрын
Basically this is a great demo and very helpful. Thanks Mike.
@MsGGmadi4 жыл бұрын
This is a really useful video Mike, thanks for taking the time and effort to post it. You're a great teacher!
@markstrong69776 жыл бұрын
Ive just had a few panes of glass break on a greenhouse that was in a garden of a house we bought and as its my first greenhouse i didnt have a clue how to go about changing the glass panes but this video is fantastic and explains everything clearly. The gentlemen took time out of his day to record what he was doing,how to do it so we should be grateful not complaining about the quality of the video or what the gentlemen keeps saying..keep up the great work Mike..brilliant
@jankowalski1436 ай бұрын
Thanks for the video....basicly...😅
@johnbellamy34064 жыл бұрын
I've watched this so many times. It is really helpful just to see how the bits fit together etc. Thanks.
@SamGSXR5 жыл бұрын
Hahah I love this. Basically he’s a top bloke
@lynneselby34538 жыл бұрын
Thank you for this valuable video, it just enabled me to dismantle my greenhouse too.
@hgerry3 жыл бұрын
Thank you! I dismantled a greenhouse today after watching this and it was great advice
@panspermiahunter75975 жыл бұрын
Yes my clips are different again, I slide a thin rod under them then lever ping them out, I didn't at first, I used pliers and broke a couple of panes of glass, never mind, I have to completely rebuild it with many new nuts and bolts, some glass but it is enjoyable, your video is good, thanks.
@allisongerman74972 жыл бұрын
Thank you for this really useful video. No idea how to get the clips back in after Storm Eunice blew out our greenhouse door. Thankfully it was tempered glass so it hasn't taken long to sort it out.
@DappsJames3 жыл бұрын
The comments basically demonstrate how the British sense of humour will latch onto a joke and not let go! Top video, brilliant demo
@HellCatt07705 ай бұрын
Basically that’s a really helpful video! Thank you!
@terriblegamer92676 жыл бұрын
Basically that is the best video I have watched all week
@tonypradioshow2569 Жыл бұрын
Not enough detail about dismantling the frame.
@bwq1we4823 жыл бұрын
Basically told me everything I needed to know. Thanks! :)
@maverickf133 жыл бұрын
This is so helpful. I couldn’t find anything else like it on KZbin!
@truthgha5 жыл бұрын
thanks so much. this helped me save my parents greenhouse who passed away.... Yeh!
@sheilawilliams28806 ай бұрын
Hi Mike B. I've bought mini snipe nosed pliers, but I'm still struggling to remove the square metal clips. Are you putting the pliers behind the main part of the clip (to get to the back piece) or nipping the back piece against the front? I hope I'm making sense. Btw, my greenhouse is an 8ft x 12ft (with three horizontal rows of glass on the roof)
@yuhuagreenhousediffuserefl79974 жыл бұрын
Home greenhouses are getting more and more popular, thank you for sharing this video.
@Xerosignalz Жыл бұрын
That was basically very helpful. Thanks! 😁
@rosiabbott2535 жыл бұрын
Thanks...not sure about doing it myself, but this makes it look doable. Will have a go.
@hughgilchrist54638 ай бұрын
Best thing to do is download the assembly drawings which gives you the glass sizes and where they should be go that’s what I did and it made the whole process a lot easier
@Bkwankelobi2 жыл бұрын
Thank you for the video! I need to do this with the same greenhouse in my backyard from 1970. Is it possible to replace the rubber strips?
@mikeb10432 жыл бұрын
From what I remember the rubber strips slid into a channel on the aluminium pieces. I've found a bit of washing up liquid will help them to slide out. Not sure how you will find replacement rubbers. There are lots of companies that sell synthetic rubber extrusions by the the metre on line. Once you know the dimensions try searching on eBay or just google.'replacement greenhouse rubber seals'. Good luck. Mike
@Bkwankelobi2 жыл бұрын
@@mikeb1043 Thanks, Mike! Great video!
@julieembury1402 Жыл бұрын
Great video! Thank you
@michaelhoare52912 жыл бұрын
Superb detail. Thank you.
@BlindLemonMeringue9 жыл бұрын
cheers, just decided to watch this vid as dismantling cheap greenhouse bought on Ebay. Some good tips.
@TheMuleVariations8 жыл бұрын
BlindLemonMeringue h
@bethdavis18125 жыл бұрын
Basically a great video thank you lovely very helpful.
@GlenBenton69 Жыл бұрын
Thanks very much for this!
@sheilawilliams28806 ай бұрын
As an afterthought, what is the best way to clean the glass please? Any help will be gratefully received. Thanks
@mikeb10436 ай бұрын
I used soapy water and a soft bristle brush to get the green stuff off. A microfibre cloth to finish if it's not going to rain!
@graememoore22708 жыл бұрын
This basically just helped me dismantle my greenhouse.
@danielvallsvara3984 Жыл бұрын
I have two greenhouses like that and I would like to make one big one, is that possible? Thanks
@mikeb1043 Жыл бұрын
Hi. Well, in theory no, but it depends on your mechanical capabilities. Certainly not without pitfalls I would say. You could possibly remove the glass in the back walls, put the two back to back, line them up and mark and drill a series of holes around the frame. You could then nut and bolt the two together. I can't remember if the roof overhangs the frame. If so you would need some sort of spacer between them (square section UPVC perhaps). You would need to put some sealant in the join to make it weatherproof. There would of course be the original aluminium frames from the backs, in the middle inside. Don't remove those as they will make the structure rigid and stop it flexing around in a wind. If you do it be very careful, lots of opportunities for injuring yourself. Good luck - Mike
@danielvallsvara3984 Жыл бұрын
@@mikeb1043 thanks a lot.
@ridealongryan7 жыл бұрын
Will head down the plot tomorrow and see if the clips are the same and try to assemble. Thanks!
@davescopes2494 жыл бұрын
I was just having a giggle at how many times you was say basically when it popped up on the video saying sorry for keep saying basically. Lol. Great video though. Basically. 🤣👍
@rickybrown433 ай бұрын
Thank you so much
@slavstoianov Жыл бұрын
Many thanks
@sandeshdsouza73375 жыл бұрын
Am I missing the reassemble part of the video?! Or will you just ask me to play the video backwards?!
@acspeter73 жыл бұрын
Thank you for sharing this
@truthgha5 жыл бұрын
where do I order the rubber strips/ clips/clamps? repalcement
@mikeb10435 жыл бұрын
On mine the panes were the same size apart from the triangles. So it was obvious. Cheers Mike
@jangriffiths13054 жыл бұрын
Mike B I have panes of roof glass whic have slipped Lea I an inch gap between the pane ,,,no why can I push it back up It’s won’t move at all have o got to smash it ?
@printingkent8 жыл бұрын
loved all the basically s :)
@SPJ77478 жыл бұрын
Super helpful! Thank you so much!
@PhillGee5 жыл бұрын
Basically, a very useful video
@lindapenney52075 жыл бұрын
Thank you for sharing my friend
@EducatorsinVR6 жыл бұрын
Thank you. Very helpful.
@KingFisherTV7 жыл бұрын
100% sure, i got this very same greenhouse from Bridgemary today? have you just had a sale on your house Mike? Shaun.
@mikeb10437 жыл бұрын
The greenhouse was sold some time ago so it's possible. Good luck with it, hope it proves useful! Regards - Mike
@kenallen83863 жыл бұрын
Thanks for sharing
@FunkyFish133 жыл бұрын
Thank for video !!!!
@ariddihough6 жыл бұрын
basically brilliantly helpful, basically
@philrobinson0058 жыл бұрын
Thanks for that .Very helpful..
@Juststuartt2 жыл бұрын
Basically that was a good video
@charlestunnard6555 Жыл бұрын
Basically no mention of removing glass from window or actually removing the window from greenhouse.😢
@mikeb1043 Жыл бұрын
At about 2:30 into the video I remove a glass pane. Hope that helps (basically!)
@MaretaMeliana5 ай бұрын
Apa nama klip nya paman
@mikeb10435 ай бұрын
Is it details of the glass clips you require? I obviously cannot know what clips are fitted to your greenhouse but I would guess most types would work. I did a search on Ebay and there are many types available at reasonable prices. See link below. Regards - Mike www.ebay.co.uk/sch/i.html?_from=R40&_nkw=stainless+steel+greenhouse+w+glass+clips&_sacat=0&_sop=15 Apakah detail klip kaca yang Anda perlukan? Saya jelas tidak tahu klip apa yang dipasang pada rumah kaca Anda, tetapi menurut saya sebagian besar jenis bisa digunakan. Saya melakukan pencarian di Ebay dan ada banyak tipe yang tersedia dengan harga pantas. Lihat tautan di bawah. Salam - Mike
@kingswoodserendipity67588 жыл бұрын
wheres the reassemble part of the video?
@michaelhall97226 жыл бұрын
Press the rewind button.
@truthgha5 жыл бұрын
should I number/mark glass to show how to reassemble????
@jimjones8208 Жыл бұрын
you are putting the glass clips in wrong mate.
@samsmalley57265 жыл бұрын
New drinking game Take a shot eveytime mike says basically
@m1at18 жыл бұрын
Great video. Shame about the quality. Thumbs up!
@regburgundy87014 жыл бұрын
So, to recap, basically..............
@graememoore22708 жыл бұрын
Basically.
@breathevideochannel49344 жыл бұрын
Title is misleading as it does not show reassemble.