Honda CX500 Cafe Racer- Engine rebuild- Ignition system - Episode 27

[@gabrielcullenmusic6277]

That was a great video well explained I'll be pulling my cx apart this weekend to do same job thank you mate 👍

[@markewins9662]

Found this video to be REALLY good. I am rebuilding a trike for somone at work at present. When he first got it it was a mess! Could not start it. Bought a new ignition switch, and it fired up! Although the trike was a mess, the engine sounded really healthy, and quiet. However, since stripping it down, struggling to get it started. I think somewhere I have got my wires crossed, or, ignition timing maybe 180 degrees out. When I took engine out, I noticed quite a bad oil leak from the ATU cover. So changed gasket. But I also removed the plate with the two pick ups on it. Cannot remember if I removed the cam for the ignition pulse. So I am hoping I have got it 180 degrees out. I will also get my ohm meter set at 2k and check resistance, and continuity for earth. Big thanks for video.

[@douglasmckay5161]

Thanks so much for your video this will help me out

[@memybikeni9931]

Good vid, mine had the CDI and I replaced that with an Ignitech due to a faulty stator not powering the CDI. I thought your stator wires looked different, due to it being a TI I guess.

[@abmgarage5185]

Hi. I did the same thing on my cx but i noticed that you can move the pointer cam without unscrewing the main bolt. Thoe this thing is normal? thank you