HOW I FIXED THIS PORCHER LEAKING AUSSIE TOILET

[@coralieofjumpwithnofear]

I finally found someone doing the same toilet that I have that was leaking. I couldn’t figure out how to get the damn flushing mechanism off, but your video helped. Thanks!

[@Yosemite_Sam]

You don't have to stretch the seal over the top. On the stem are 2 press in catches that will allow that top piece to be taken off and the seal replaced easily. Also double check the tabs that lock the tower section aren't worn or loose as this will let the tower tilt and not seal. Check the cistern level to ensure it is not too full. The adjustment screw is the white plastic on on the water inlet module.

[@kevlec1947]

Here is the Part number for the Complete Valve Unit including the Buttons from Reese Plumbing 1843114 cost $85 as of June 2024

[@rashpalrana-n5n]

where can i buy this part from? bunnings seals are not helping me. I can’t find this part anywhere. please suggest

[@MrFlebbert]

@testandtune6096 Any help on how to get the top off the red top inlet valve to replace the washer in there?

[@MrFlebbert]

Ok figured it out, there is a red tab in the top of the cap that needs to be pulled out and then is easily twists off

[@mmango635]

how did you pull the red tab off?@@MrFlebbert

[@MrFlebbert]

@@mmango635 it just pulls straight up, I used a pair of pliers to do it

[@jessicamichalak2147]

This video was so helpful, thank you! I had also purchased a bunch of seals to try, I'll get the Porcher part now, looking forward to no leaks! I was also wondering where you purchased the part? I can't find it anywhere to purchase? Thank you!

[@davinwest466]

Thanks for the help

[@cheapshots2]

How to adjust the height of flush button plate before putting the lid on thanks

[@67wogval]

Would like to know how to adjust the flush for a bigger more water flush?

[@Yosemite_Sam]

The water level is adjusted by the white plastic screw on the inlet unit the hose attaches to. Don't fill the cistern above two thirds.

[@regenburn]

Legend! Thanks

[@katepatterson4241]

Reece are exclusive supplier

[@bradmckinnon7269]

very helpful!

[@TIPh0enix]

Funny looking N54 lmaoooo

[@testandtune6096]

Ohhh man how things have changed in such a short period. Just wait, im doing his pool pump replacement next.

[@daveduncan8123]

I watched another video similar and the seal unit turned out to be a WATERMARK make.

[@igotaction]

On the next episode of Test and Tune Andrew will be putting a MHD stage 2 tune on the shitter.

[@testandtune6096]

Its a worry.... LOL

[@michaelmcleod8419]

Thanks for the helpful video, but next time, you could put the punchline in the first 5 seconds instead of making me watch 11 damn minutes.