How To: Flush/Change your coolant in your RB25!

[@Glock18Kid]

Been wanting to do this for a while now, but I was putting it off thinking it was a big job. Beautifully explained and demonstrated. Thanks mate!

[@DarylKinslow-fh6fc]

Very informative, will definitely help me with my 33. Thank you

[@RFSA180]

RB25 owner here. Subscribed mate. 🇬🇧

[@JoeyVanVeenYt]

I need to do my cars 😎 nice work!

[@sedangarage8241]

Let’s get it done dude!

[@tylerl2690]

“2 things that can get f*cked, the rona and the rain” 😂😂 had to subscribe after that one

[@sedangarage8241]

Hahahaha I’m glad I made you have a giggle 😂

[@7aexvn]

Where's the best place to put the jack stands? I jack up either from the tow point or at the rear I'd just the diff, but setting it on stands scares hahaha

[@sedangarage8241]

Rear cradle at the rear then the front of the chassis rails or the tow hooks at the front will be fine mate!

[@DifferentShadow]

hi friend, I changed a water pipe and now my skyline r33 eats all the coolant, I think there are air bubbles in the cooling system. You unscrewed that cap at the top of the engine and left it open until the coolant came out without bubbles right? Do you then close the cap with the engine on or off?

[@sedangarage8241]

Hi mate. Engine running with the cap off to bleed it. But also, up on your intake manifold towards the front of it should be an 10 or 12mm nut, undo it and take it off and rev the car while trying to bleed it. It’s the highest point of your cooling system and will help the bubbles escape.

[@DifferentShadow]

@@sedangarage8241 thank you so much my friend

[@sparklingsams3155]

Hey mate what's the bolt below the water feed . Is it a water feed aswell. I'm thinking to use it for 25de + T convertion. You take that bolt water comes out.

[@sedangarage8241]

That bolt is the block drain mate. That’s where all the coolant comes from. So it can’t be used

[@sparklingsams3155]

@@sedangarage8241 sweet. Thanks mate. What about the throttle water feed and heater return for the turbo then.

[@YMWnaFUN]

@@sparklingsams3155what did you do in the end?

[@omarelcheikh7306]

Did you make that does pipe

[@sedangarage8241]

Yeah mate I sure did

[@omarelcheikh7306]

How much would it cost to make me one ??

[@sedangarage8241]

@@omarelcheikh7306 if you were to PM me on Instagram we can have a chat mate! @SedanVlogs

[@sedangarage8241]

My Instagram account: instagram.com/sedanvlogs_/