How to install a Back glass seal on a 1956 Ford Pickup

[@neilkinney6600]

Great video and instructions, but what about all this sealant you claim one needs? You never mentioned that! Some claim sealant is needed others say no! Which is it?

[@lucky.t.7233]

Um at what point does the glaze get used?

[@kriegsmarine33]

I appreciate the video, however, you said one of the tools needed was thew glazing compound and I never saw you use it. I checked your windshield install as well, and you didn't use it there either, and both videos say your install is complete?

[@denniscarpenter]

The glazing compound is optional as shown in the graphic. Some will use the compound after the install by lifting the lip and using the caulking gun to apply a bead under the gasket. Thank you for your input.

[@Murc_roadster]

I was looking for that also. It almost stopped me from doing this project . Good thing I watched the whole video

[@thisoldjeepcj5]

Yep, you make it look easy. Do you have any videos where you had to fight it or even broke the glass?

[@Jbezley87]

That weatherstripping fits a lot better then mine does. Mine is about 2 inches too long. Figured I could possibly cut the seam and reseal once shortened?

[@boilermaker8124]

I just ordered the back glass seal from your website for my 69 Ranchero. I hope installation goes this well. I wonder how much was edited out, lol.

[@rudsaki]

I bought one of your gaskets for the rear of my 1970 F250. Which side is the inside and which the outside? One side is round and the other has a bevel. Also it does not seem to have any shape, but I see you put the "bar" on the bottom. C7TZ-8142084-A

[@markdierking9347]

Thanks, Dennis for posting. I am wondering if it is very possible to re-use the older gasket on new fixed rear door window on a 1990 Econoline Van that was burgularized? Your insight would be helpful and appreciated. I realize it would not be reccommended but a spare part is unobtanium, afaik.

[@rickwhetstone1365]

You didn’t use butyl is it not needed

[@denniscarpenter]

The glazing compound is optional as shown in the graphic. Some will use the compound after the install by lifting the lip and using the caulking gun to apply a bead under the gasket if needed to fill voids

[@donnixon3528]

What about the compound

[@ac5015]

Great now all I’ll need is an f-100 to install it in.

[@kz4506]

To easy