How To Install Front Lower Ball Joint on 2015 Lexus IS250 | IS350 2014-2020

[@JohnDoeses]

thank you. please do more is250 videos!

[@albunbury]

Thank you for this video. My boyfriend found it helpful

[@momo5757]

Thanks for the support.

[@vicv871]

Just forgot to show the difference on play between a good and a bad ball joint, another thing help full will be why or show the noise the old ball joint was doing. I have an ISF and they look pretty similar mine is doing a clunky noise at low speeds and tires are getting worm from the inside. this vide will help a lot to do the job im new but this looks easy. got tools got time thanks for sharing.

[@momo5757]

Hi bro, thanks for the advice I will try to do in the next video, and my car was not making any noise, the parts are just worn out, but I get the car new and you can feel the difference when it was new and now that it has 100,000 miles. When I go over a bump or a turn or high speed, doesn’t feel the same, that's why I replace many parts, and if the tires have internal wear you have to install figs engineering bushings to fix the problem.

[@soulmusic8823]

Me encantó . Gracias

[@LuisMartinez-pd1bl]

Great work my dude

[@momo5757]

Thank you for the support. I will upload more videos soon.

[@leojohnwayne1422]

Where did u order the ball joints?

[@dadstro]

What wheels are those man they look sick

[@momo5757]

Thanks Bro, The brand is Albatross and they have it staggered too, they look similar to Rohana wheels but for me Rohana wheels they look simple.

[@RobD1]

Where did you buy that specific tool at? The first one and what brand is it?

[@momo5757]

The ball joint separator I got it from Harbor Freight Tools, is more then 10 years old and still in great condition since the tool is generic is not brand it. Or if you are talking about another tool just let me know on what minute appear the tool.

[@gelatoconnoisseur5389]

My gs300 started making a squeak noise after I hit a speed bump too hard. The noise only comes from passenger side when there’s a change in suspension/ground level. Could it be this or ball joints?

[@momo5757]

Is really hard to tell true here, but just check the lower ball joint and the upper control arm, even if the rubber is not damage, but you see a little bit of grease out on any, that would be the bad one, because internally it would have a play already.

[@jri238]

I got really bad toe out tires :( after

[@momo5757]

Hello my friend, after you replace front lower ball joint, you don’t need to do alignment, it’s not required for this. I didn’t do it on my car and not issues at all. But if you have bad toe after you replace this parts, what I suspect is that the parts were installed opposite, the parts are very similar from left and right, if this was the case. I’m 100% sure that is why your tires were damaged because change the angle of the steering knuckle, if the parts are aftermarket they are not marked right or left. When you remove one ball joint, you have to compare it with the one you are going to replace. What I would recommend is to check if that was the case. Any other question just comment again and I will do my best to respond right away.

[@jri238]

Did it mess up with the alignment?

[@qq3528]

Sure

[@JoseMorales-bj8px]

what ended up being the problem? i actually have the same issue at the moment, i do suspect i mis matched left and right. was that the cause? if not i will have to take it to the mechanic

[@ballzzinyourmouth8]

Wait theres no way this is 6hrs old...

[@momo5757]

Yes, I just upload the video last night.