How to properly lubricate the General Pump YG1635 High Volume Low Pressure Wash-Down Gun

Let's make this gun glassy smooth

[@MannyAguilarJr]

Great video and information Kenny

[@housewashing5693]

Thank you

[@fpplsoftwashpressurewashin8757]

Needed this information. My blue gun isn't shutting off all of the way so this may be a huge help. Thanks Ken, you're the man!

[@housewashing5693]

It sounds like your stem is sticking. Tear it down

[@ronjclm8590]

Great ! Thanks for the video Ken. I have one that I've only used at my house to wash my vehicles...plain water. And after a few times. It would no longer make the tightest stream. NOW...I know how to take it apart and see if I can find the problem.

[@housewashing5693]

Don't take it apart. Just adjust the screw in the back while holding your trigger on.

[@ronjclm8590]

@@housewashing5693 I've run that screw through the paces. All the way in & out. It did make a tight stream when I 1st got it. But after just a few uses...it screwed up. I almost threw it in the trash.

[@housewashing5693]

@@ronjclm8590 Yeah. Go ahead and open it up, look around and lube it. It might work....

[@TheFreshRinse]

Great video!!! Much needed.

[@housewashing5693]

Glad it was helpful!

[@deepsouthdiggers580]

I run the red gun and i believe that is the stainless steel if im not mistaken. I've washed approximately 500,000 sq ft of roof with it in the last 10 months and haven't had a problem. I just squirt some WD-40 in it after each use and throw it in my toolbox until the next time. I keep one of the blue guns as a backup though.

[@gregjones4844]

All of this is great!

[@housewashing5693]

Thank you!

[@robbybeavers1619]

I just pour bar oil into the slot at the top of the trigger. It fixes it for months

[@MannyAguilarJr]

@littlespressurewashing